Your cart is empty.
Your cart is empty.Product Description
Tear off the protective film.
Paste on the four corners of the dart board or other locations.
Gently press the felt board until it is firm.
Stick all the plates, and then install the dart plate.
Tauna broussard
Reviewed in the United States on February 17, 2025
It’s good quality
Ryker White
Reviewed in the United States on January 7, 2025
What a piece of garbage. The cutout is too big for a standard dart board and the individual pieces put together look crooked and sloppy. The foam is only a half inch thick and can’t stop a dart worth anything. I threw one dart from standard throwing distance with a moderate amount of effort and immediately punctured my wall. I threw three more and only one didn’t go through the foam into the wall. I started taking the pieces of the wall to put back in the box and the adhesive patches used to hang the pieces left paintless patches all around my dart board. I do not recommend this purchase.
Mr moop
Reviewed in the United States on January 28, 2025
Terrible cover. This is the worst cover ever the darts completely bled through this protection. I would not recommend and attached our photos of how bad it was when I took it off.
Cathy Stone
Reviewed in the United States on January 23, 2025
I read several reviews on this set. They are correct- it does not accurately fit a regulation dart board. I did not want to put all the mounting stickers on my walls. I used cardboard and place to protection boards on the cardboard. You can see a gap at the top and on the left and right side of the board. I will fill it in with felt or something. It works find, but I did attached the felt boards to a very thick piece of cardboard. It works for me.
Schnoodlydabobbob
Reviewed in the United States on August 8, 2024
This dartboard wall protector comes in 6 panels with 2 sets of sticky tabs that attach the panels to the wall. They were easy to put together and they hold well. The felt is thick enough to catch the darts but the darts will go all the way through if thrown hard enough. Not much damage if they go through because the felt absorbs much if the throw. This is made for an 18" dartboard but our dartboard is not regulation size. I ended up spray painting the void area. It would be nice if some felt pieces were included to fill in the space for smaller dartboards.
Jonnette Perisho
Reviewed in the United States on July 21, 2024
This is only 3/8 “ thick. My dart stick in my wall. It only extends 3” - and the hole is too big for a standard dart board. Smaller hole would have been better. Not worth it.
Jas
Reviewed in the United States on November 29, 2024
The boards are all uneven, and cut poorly. Sided don't line up. Squares aren't straight.
2ndChance
Reviewed in the United States on November 21, 2024
The pad is thin but dense. It also has some good weight to it. It does a good job stopping a metal tip dart. The silicone adhesive pads doesn't stick well on this material but does hold well against my painted wall. On two occasions, one of the panels just detached from the wall, leaving the adhesive pad on the wall. I just put it right back up, added some pressure, and it re-stuck. They provide lots of the silicone adhesive pads so perhaps I just need to use more to "share the weight". Overall, it's not a back protector. I think I probably should have paid the extra $20 and purchased a single piece design. It looks like those don't need adhesives as it is supported by the dart board itself.
Recommended Products