Your cart is empty.
Your cart is empty. Package list:
1pc collet chuck in plastic box
CB
Reviewed in the United States on September 21, 2024
It’s a collet
danielbiota
Reviewed in the United States on July 28, 2024
CNC carving,
dc-in-md
Reviewed in the United States on May 26, 2024
My cnc unit only came with a 1/8 insert. This 1/4 fit my motor perfectly and allows me to use a lot of sturdier bits in my cnc.This is a must have accessory for stock cnc motors under 300w.
Mark S Larner
Reviewed in the United States on January 29, 2024
I purchased this so I use 1/4" bits with my 4030 ProVer. It works great, but do yourself a favor by getting another nut to go with it, they are a pain to change collets out of the nut, especially getting the 1/4" out to go back to 1/8".
ZKay
Reviewed in Canada on January 16, 2024
Very soft material after two uses it falls out of the nut by itself, does not open, hard to push 1/4" shank in. Other than that, usable with some fiddling.
Gregory P. Kretchmer
Reviewed in the United States on January 13, 2024
This is an er11 collet for 1/4 inch cutters. Very handy for cutting foam and things of the nature. It fit the collet well, runs true. It is quite hard to remove from the nut as the snap ring is sharp but it can be done with a little work. Overall, I'm pleased. Remember, I'm cutting foam so if you are using very thin resharps, they need to run exactly centered and Very fast of you will break cutters in less than a second. Your mileage may very.
David B.
Reviewed in the United States on March 28, 2023
It did just as I expected. My original collar was 1/8, but need to do 1/4 surfacing bit.
Bob Lore
Reviewed in the United States on December 6, 2023
Fit well and had no issues
Airwings47
Reviewed in the United States on December 29, 2023
The collet worked perfectly. Good price and good product.
Madhav Tenneti
Reviewed in India on December 16, 2023
On the delivery, arrived a little before the actual indicated delivery, very happy with the product
Recommended Products
