Your cart is empty.
Your cart is empty.Energy Suspension 4.3121G Axle Pivot Bush for Ford Truck 2WD
Loretta E Murphy
Reviewed in the United States on January 21, 2023
A world of difference on my 86 F150 2WD ! Old rubber bushings were literally falling apart as I pulled the I-beams down. The passenger side will be a little tricky as it is further back on the frame and that beam is significantly shorter . I drilled out the old bushings with a small drill bit , being mindful not to damage the metal shells, which you’ll reuse with this kit. Once the old ones were completely removed , I used a wire brush attachment on my drill to clean up residual rubber pieces in the shells. A ball joint press works well when installing the new bushings. Make sure to grease them up liberally with the supplied grease packets.Truck now drives STRAIGHT down the road , steering wheel sits at 9 and 3 o clock down the road . I love it !!! And no more wobble at high speeds . Highly recommend if you want to upgrade your 2WD Ford I- Beam suspension!
Hill
Reviewed in the United States on May 1, 2020
Fits perfect F350 2000 Makes you pick up rider little bit stiff
marty
Reviewed in the United States on February 5, 2020
Fit perfect on a 1994 F150 4.9 auto RWD. Energy suspensions has a different part number for this application. After researching, the 3121s are definitely the correct part number for the pivot bushing replacement.
Gary Thompson
Reviewed in the United States on October 1, 2020
Great product installed with c clamp. Melted old out with torch. Mine was missing the thrust washers manufacturer is sending the washers.
Publius
Reviewed in the United States on January 11, 2019
What a difference these made in my 1988 F-150 2wd. They actually improved my steering tightness and handling. The old bushings had 170,000+ miles on them, so they were absolutely shot. Not much of a comparison since the old part was totally worn out. I'm still tickled pink with the way my truck handles after installation. Includes everything to install except you need to reuse your old bushing metal sleeve. Takes some cleaning up inside after the old bushing is pressed out. Just the right amount of their special grease is included to get the job done. Grease everything that comes in contact with metal and they will be very quite.
Benjamin Dixon
Reviewed in the United States on May 20, 2018
Made it like new or maybe even better...
Sir Ric
Reviewed in the United States on March 12, 2018
This is a perfect fit for a 94 F150 lightning. Most retailers will list a different Part Number but this PN fits better as I found on a Lightning forum. Evidently the mfr has to go through too much testing and ref tape to make a catalog change.
Bradley Pool
Reviewed in the United States on December 11, 2013
What's there to say? They fit perfectly and fixed an intermittent clunking noise that was driving my brother-in-law crazy! This was a 2000 F250 Diesel Rear Wheel Drive. YMMV.
Recommended Products
$31.71
$ 14 .99 $14.99