Your cart is empty.
Your cart is empty.Energy Suspension 2.9101G Bump Stop Set for Jeep TJ
Robyn R. Jones
Reviewed in the United States on July 20, 2024
Rubber bump stops worked out great, perfectfit, easy to install and made the ride a lot better,
Bart Hollingsworth
Reviewed in the United States on September 26, 2023
Fairly easy to fit in with a little dish soap and should hold up much better than the factory rubber/foam pieces.
Michael Frost
Reviewed in the United States on December 18, 2023
Worked good on willys pickup project with crown bumpstop cups
Austin W.
Reviewed in the United States on November 25, 2023
The quality on these is nice. Much more dense than the OEM foam type and stiffer as well. They fit just fine although they were a little bit of a pain to get to stay in place. A little dish soap helped get them in the cups but the downside to that was they were slick and the pressure from the cups wanted to squirt them back out. However, once in place I gave them a few twists by hand to add some friction and some pressure from a pry bar and they've stayed put since. Overall nice product and I'd buy again.
Dave in San Diego
Reviewed in the United States on June 12, 2022
Easy install. Ive watched youtube vids on bump-stop r&r way overcomplicating this. This can be done readily without removing the coil, nor blocks of wood, no lube... I used a scissor jack for the frame, a bottle-jack on the axle and a 20" crowbar.1) Jack-up Jeep From Frame.2) Jack-Up Axle3) Remove Tire (place tire under jeep for safety)4) Drop Axle to open up coil.5) Remove Existing Bump Stop.6) Insert New Bump Stop through coil.7) Hold with one hand of stop, then use end of crowbar to force stop into position against coil (no need to grease)Raise axle, install tire repeat.
Chaidez
Reviewed in the United States on August 19, 2021
Super easy to install. I just lubed it up and jammed it in there with my bare hands. As long as you have the right angle to jam it in there, you dont need a press or anything of that sort. Once it gets inserted, it locks into place as the coupler has some indents to bite down onto it.Energy products have yet to disappoint. This is a direct fitment for stock components.
Troy G
Reviewed in the United States on January 15, 2020
Some people talk about how hard these are to get into the cups. Its not hard at all if you use a pry bar. Put a little grease on bump stop and just get it started. Use the pry bar and it went in with minimal effort. Seen others doing this on Youtube and struggled doing it too. Think about the angle of pressure, use pressure forcing it straight up into the cup and its a easy day.
shortydog
Reviewed in the United States on June 16, 2015
Product seems to be of good quality as is all of Energy Suspension products, but this particular item does not fit a Jeep Wrangler TJ as stated, they are to large and do not come close to fitting into the bushing cup. I could be stupid and trying to install them incorrectly but I don't think so.
Recommended Products
$46.95
$ 22 .99 $22.99