Your cart is empty.
Your cart is empty.ENERGY SUSPN Energy Suspension 16.7106G Rear Right Trailing Arm Set
Delta
Reviewed in the United States on October 29, 2023
Well it doesn’t work with 91 CRX hardware
keyla
Reviewed in the United States on November 2, 2021
Product does fit 2000 Honda CR-V rd1 rear trailing arm for Manuel transmission 4wd ,stuffing up the rear a lot!!!👌
LG
Reviewed in the United States on August 31, 2020
The product was as described and went in better than I had expected.
Alexander Cordero - Rentas
Reviewed in the United States on May 9, 2019
After 1 year with them on they tighten up the rear end and the car handles greatly around the corners it doesn’t feel so loose no more great pick up for those beat up Integra trail arm bushings I had before .
MrHilarious
Reviewed in the United States on January 27, 2019
Excellent product. Not the easiest install but easier with the right tools. Excellent product so far
Goose
Reviewed in the United States on May 20, 2018
Installed on a 1999 Honda Civic and they work great. Have not put many miles on them as of now but working on it.The product comes with 2 bushings and a packet of grease. It is important to utilize the grease for install and to improve suspension life of the bushing.Removing the old bushing can have a range of difficulty from it falling out to burning/pounding it out if you have the control arm out of the car. This kit does not include the center pin and you must reuse the OEM pin to complete assembly. The best technique I found to get the existing rubber off the OEM pin is to heat it up with a torch to the point the rubber starts to smoke. Take some pliers to stabilize the pin and a metal putty knife to scrape the rubber off. It should practically fall off.Please note the original sleeve the OEM bushing was in must remain in the control arm for this part to work.You will also need a tool whether from Honda or one made out of all thread and plates for install. Grease makes the jobs easier.
Michael
Reviewed in the United States on March 21, 2016
these are really good, a little hard to install but good. i honestly recomend oem replacement because the design can cause movement side to side
PJ Fresh
Reviewed in the United States on November 8, 2013
I lowered my EG to minimize the distance from the wheels to the rear body. The stock bushings were very worn, and made the ride uncomfortable. After installing these, the ride was quiet and much more comfortable. They also provided very good traction when taking turns. I didn't have my own press to press them in, so I found an auto shop in town that pressed them in for me for $5.
Recommended Products
$48.92
$ 22 .99 $22.99
$30.45
$ 14 .99 $14.99
$89.99
$ 40 .99 $40.99