Your cart is empty.
Your cart is empty.Product Description
Designed for connecting a standard 8-10mm diameter gas inlet jet to Bunsen, Tirrill, Meker and other laboratory burners. This premium quality neoprene tubing hose connects your laboratory burner to a fuel source such as liquid propane, butane, or natural gas. Hose measures 3 feet (0.9m) in length, and both ends are designed to fit gas inlet connectors with diameter of about 8-10mm. Inner diameter at tube ends measures approximately 7mm, and outer diameter is approximately 12mm.
NOTE: The hose should always be used in a lab setting connected to a gas jet and never connected directly to a fuel source. Due to the nature of neoprene, please inspect hose before every use to make sure there are no holes or cracks.
Esteban
Reviewed in Mexico on September 23, 2024
Resistente, cumplió con el trabajo para el cual se adquirió.
dolphin
Reviewed in the United States on October 22, 2024
The hose cracked open on both ends within just a couple of years and with minimal usage!
Dana Adams
Reviewed in the United States on February 23, 2022
The media could not be loaded.
JF
Reviewed in Canada on August 9, 2021
Works, but I had to cut an inch or so off one size to fit the barb on the propane regulator.
Dr. Barry Simmons
Reviewed in the United States on April 28, 2021
One end fits bunsen burner, but other end too big for wall outlet. I cut off the big end and electric drilled/reamed opening to adapt to wall outlet/cutoff. Hose is made well and can be made to fit
Hugo I. Morales
Reviewed in Mexico on September 7, 2020
Excelente manguera de conección, muy buena calidad y ocupará conexión de 1/4 que también encuentras aquí en Amazon
Customer
Reviewed in the United States on August 10, 2020
great just what I needed
Richard
Reviewed in Canada on June 11, 2019
Work perfectly...good length
Murf
Reviewed in Canada on March 13, 2019
Perfect condition as expected
johnprosser
Reviewed in the United States on June 18, 2018
This hose has expanded and reinforced ends which have a larger inside diameter,they are not 0.25 inches but closer to 0.375 inches, They fit the Bunsen burner hose barb but not the gas regulator hose barb.
Sean
Reviewed in the United States on May 29, 2016
High quality lab hose.
Anthony Garofalo
Reviewed in the United States on December 31, 2015
Works great with my I will report back if I run into any issues.
Michael
Reviewed in the United States on April 30, 2015
Working like a charm on one of our burners in one of the labs. As others go bad I'll replace them with these.
Recommended Products