Your cart is empty.
Your cart is empty.The Edelbrock Metering Rods are designed for use with the Edelbrock Performer Series and Thunder Series AVS carburetors only and not with any other brands. These metering rods allow you to fine-tune your carburetor for optimum performance and are used to control the air/fuel mixture. Since metering rods are available with different step combinations, it is possible to independently alter the air/fuel ratio for both cruise and power modes with a single rod change. The small area at the tip of the rod is the power step and the thicker area next to it is the cruise step with a dimension of 0. 070 x 0. 047. These rods can be changed in seconds by removing the single hold-down screw and are sold as a pair.
Xanwar1
Reviewed in the United States on July 4, 2023
Twice I received different size jets in the same original Edelbrock packaging. Use a magnifying glass and inspect the stamping number for size before you install these.
sonny ventle
Reviewed in the United States on June 8, 2023
Worked perfect part as described
Susan
Reviewed in Canada on April 21, 2022
The product fit perfectly and did the job it was supposed to do
Walter S. McNeil
Reviewed in the United States on August 26, 2020
found a broken metering rod and ordered these, these are the factory rod for an edelbrock 1605 600cfm and installed perfectly and my car fired up perfectly after 8 years sitting
Greg Montoya
Reviewed in the United States on June 28, 2018
Not leaving a rating for metering rods, am leaving one for the Edelbrock carb. Love how simple it is to mix/match rods and jets without removing the carb itself.
tomoya
Reviewed in the United States on April 16, 2015
good!
Recommended Products
