Your cart is empty.
Your cart is empty. Designed to help you mount rear window louvers, along with some great privacy and sun
protection. If you're looking to install a rear window louver, these kits have everything
you need to make your installation a breeze and ensure a perfect fit and finish.
Fitment:
Available for Ford, Mustang, Dodge, Challenger and Camaro
Installation Detail:
step1. Clean the surface area of C-Pillar glass;
step2. Measure the 3M double-sided tape position of the louver on the rear windshield;
step3. Peel of the 3M tape and stick it on the glass;
step4. Align on the 3M tape position and tighten the attached nuts to complete the installation.
Geovannie Pantoja
Reviewed in the United States on February 23, 2025
The product itself is great, the pieces fit perfectly with my louver. The only downside is the double sided tape, it did not hold my louver well, the tape was installed on a hot day and was left for a few days sitting, I drove the car and my louver almost flew off, I purchased the gorilla double sided tape and it fixed the solution. Overall I give it a 7/ 10 only because of the double sided tape.
Gibran
Reviewed in the United States on September 29, 2024
Love it!
Nicholas Brantley
Reviewed in the United States on August 27, 2024
Missing 3m tape
Derek
Reviewed in Canada on May 4, 2024
Works great,nice and sticky
Vic Suro
Reviewed in the United States on November 13, 2024
Easy to use, have all the last hardware needed, the adhesive holds well. Very pleased.
David F.
Reviewed in the United States on November 10, 2024
Very good quality but make sure you buy an adhesive promoter as an extra peace of mind to safely secure your rear window louvers.
xtreme industries
Reviewed in Canada on October 20, 2024
Still holding strong over a year later. Went on easy. Held louvers with no problem.
Edgar C
Reviewed in the United States on October 18, 2024
The product description should include “steel plates with powder-coated finish.”Happy to finally find them made out of steel and not plastic. My louver came with plastic hardware but they’d wear out quickly or break.And the fact that comes with a rubber washer and a steel washer, perfect.On my louver I had to make the holes slightly bigger with a step drill bit since the hardware screw was bigger and also to have some play when installing the louver. Fyi, use a 10mm socket.Btw, I purchased my louver on American Muscle and they don’t carry steel hardware.
Mustang 07
Reviewed in Canada on April 17, 2024
Makes it easy to remove louvers to clean window.
Gabe C.
Reviewed in the United States on December 3, 2023
I had originally attached my louver using the included hardware kit that came along with my IKON louver. However, it appears the screws were not long enough to get a sturdy, tight fit. I was afraid it would fly off as I’m driving down the highway. I decided to invest in this hardware kit and can definitely state this kit exceeded my expectations! Perfect screw length, strong tape adhesion, and comes with everything you need to stabilize your louver. I strongly recommend purchasing an adhesive promoter to further strengthen the bond. I then coated the sides of the hardware with Gorilla clear sealant to prevent water from seeping through the 3M tape. So far, the louver has remained intact and no signs of loosening.
Felisha Carrasco
Reviewed in the United States on October 31, 2023
The media could not be loaded.
eieio
Reviewed in Canada on December 10, 2021
came with a full set of 12 of everything. Only needed 6, so have spares.used adhesion promoter to secure to glass - bought separatelyalso used clear silicon around edges to ensure water doesnt get under tape.This technique worked really well on my last car. Its not mentioned in their instructions.
Recommended Products
