Your cart is empty.
Your cart is empty.Product Description
fitments
fitments
If your factory thread size is different Need to purchase a set of open end lug nuts in the correct thread pitch (your factory thread pitch) to complete the installation
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs; 2) The wheels need to have the open slots (cavities) between mounting holes.3) Purchase a set of shorter studs and replace them with the factory studs.
david Baumann
Reviewed in the United States on September 10, 2024
I got these spacers to run some newer gmc wheels figment was great but I would advise you to not use the spline drive locking lug nuts the studs are to long. If the locking lug nut has an open end on both sides to allow the stud to pass all the way through it. If that makes sense. Otherwise quality spacers for the price.
Andrew carruth
Reviewed in the United States on May 13, 2024
It work for the truck you will need deep and shallow sockets to put spacers on comes with the red lock tight make sure you use it appropriately, I have towed with it no problems definitely a great buy!
Damian
Reviewed in the United States on March 16, 2024
Would leave zero stars if I could. Only received 2 out of 4 spacers. Tried to contact no response.
Daniel Moseley
Reviewed in the United States on October 10, 2023
GOOD QUALITY! BUT you have to Buy smaller lugs the holes that your lugs go through are to small for a 7/8 sockets so you have to get 3/4 Inch lugs
Danil
Reviewed in the United States on March 5, 2022
Spider
Reviewed in the United States on December 11, 2020
High quality material
Darla H.
Reviewed in the United States on December 5, 2019
Worked exactly like they were supposed to.
Evan Burch
Reviewed in the United States on December 16, 2019
Came all packaged up very professional! Didn’t have any dislikes about it!
Recommended Products