Your cart is empty.
Your cart is empty.Product Description
Suitable For all Types of Vehicles
gregory ahrens
Reviewed in the United States on March 7, 2025
This thing is solid. Works great for getting in and out of the back of my Ram 1500 Promaster.
Joe
Reviewed in the United States on February 6, 2025
Super useful. Very, very strong. The coating doesnt hold up very long though.
Libby E.
Reviewed in the United States on February 23, 2025
Very heavy solid hitch step. Easy to install. Fits very well on my 2020 Ford Ranger.
J. L. Johnson
Reviewed in the United States on February 22, 2025
Very well built and well designed. A heavy, solid steel step that also acts as an excellent recovery point. It's solid and stable with no rattles using the supplied bracket kit which is also exceptionally heavy duty. The u bolt is quite thick and plate that stabilizes the hitch is about ¼" contoured steel. Finish seems good, though I suspect that based what it and where it's located periodic painting will be needed. (all hitches take a beating over time).And, it's unlikely anyone will be bumper tapping in the parking lots with this mounted. At least not without serious damage to their vehicle. I have it on a 2016 Sequoia and its perfect. Recommended.
Sigma006
Reviewed in the United States on January 31, 2025
Great tie down point for straps when hauling kayaks. Nice for stepping up on also, sturdy and well made. Also gives me piece of mind against rear end fender benders.
hardesty
Reviewed in the United States on March 7, 2024
I love this thing! first off it protects the rear of the truck if somebody runs into the back of me in traffic or in a parking lot. Also you can hook a chain to it or a tow strap to flat tow somebody it's thick it's heavy you are not going to bend or Break It!! I like that I can see it in my rear view camera gives me a reference plus I have noticed people have been staying farther off my rear bumper at street lights lol. I installed it upside down so it was a little higher and you can't use the anti rattle plate like that the U-Bolt is not long enough which sucks but I don't hear it rattling much. The only thing they could do better is make the U-Bolt just a little bit longer. Love the Prius spear!!!Update just used this to pull another stuck truck that had a trailer about 10,000 pounds used a soft shackle to hook to this! it was awesome so much better than a ball you do not want to pull with a ball they can break and go flying so this is great for pulling people with chains or toe straps could no be happier!
popy_guy
Reviewed in Canada on November 9, 2024
As others have pointed out paint could be a little harder.They could've put grip on both sides of the step so it could be reversibleI wish the hitch part was a little longer so it would protrude more from the rear of the vehicle.There's no reason for the square tube inserting into the hitch to be full because if it where hollow it would be possible to install an anti-rattle inside the tube as well as use the supplied ubolt-type one. Broke the bolts to the supplied ubolt-type anti-rattle and because of design choices it will be difficult to find a replacement that fits. Anti-rattle makes it harder to steal.Overall good purchase.
Gramps
Reviewed in the United States on November 24, 2024
The step shaft fit the receiver hitch on my Tundra just fine. In order to get the U-bolt to grab squarley I had to use the second pin hole so the step went in far enough. With the U-bolt in place it is very solid. The paint was fine-no chips/rust/scratches. In order to remove the step you need to carry a 17mm wrench or ratchet. You can slip the U-bolt, with bracket and nuts, over the shaft before inserting it in the receiver hitch. It simplifies tightening the nuts. In order for someone to steal the step they'd have to have an appropriate wrench or ratchet. So, it's not impossible just time consuming. You can of course buy a locking pin if desired. The U-bolt should have come painted so as to not rust and match the step. It gives a real nice solid step from which you can swing your leg over the tailgate to get in the truck bed. The step bumper is just too narrow to do this safely. Someone referred to it as a Prius Spear-LOL.
Dilly
Reviewed in Canada on April 10, 2024
This did not fit 2024 Toyota 4Runner standard 2” hitch. It was very tight and could not be inserted unless you shave off quite a bit. The return postage cost me $41. The seller said it will be refunded on return. However all my emails and follow up was ignored by the seller after the return. Amazon refunded the shipping cost and offered a full refund.
David R.
Reviewed in the United States on August 15, 2023
I purchased a different hitch step and returned it to purchase this one. This one is a solid, heavy weight hitch step. Seems well constructed and I hope that it lasts years. While I very much like the design and the hitch stabilizer which stops any rattling from the hitch, there were a few chips in the paint (I'm not sure if this should be classified as powder coat). Knowing that this is iron and would rust quickly, I simply took some black paint and a Qtip and filled any exposed metal to avoid the impending rust.... It has worked so far. This hitch step is solid and well worth the price, just requires a little prep.
Jase
Reviewed in Canada on November 24, 2021
Lightening fast shipping, great addition to my truck.
Recommended Products