Your cart is empty.
Your cart is empty.Dremel's line of Max Life high-performance accessories provide long-lasting performance and impressive durability. Built to give you longer lasting, stronger performing, versatile accessories. The Max Life 115HP Carving Bit is coated in Titanium Nitride and is engineered to last 2X longer than the standard, non-coated Dremel 115 carving bit. For use with all Dremel high-speed rotary tools, 5/16" (7.9mm) high-speed cutter works well for detailed material removal in applications like shaping, carving, engraving, hollowing, precision cutting, grooving, slotting, inlaying, making tapered holes or freehand routing. The cylinder shape of the carving bit allows for deep removal of material, cuts flat areas, round edges and makes stop cuts and V-cuts. The accessory tip makes flat bottom slots and grooves, flat side cuts, and makes V-cuts when held at 45-degrees. Two bits included per package.
Jaime
Reviewed in the United States on February 6, 2025
so these 2 are someone else..power to a whole different level
w sm
Reviewed in the United States on February 16, 2025
dremel bits are hard to beat
David
Reviewed in the United States on February 15, 2025
I bought these to rout out hinge recesses in wood doors, for thicker spring load hinges that I installed. They work very well, and are very sharp. Took only a minute per hinge recess to deepen each one. Much better and cleaner than using a chisel to deepen the recesses.I have also used them to enlarge door lock cut-outs in door frames when I adjusted the strike plates to get doors to fit tighter against the seals.Highly recommended!
JJones
Reviewed in the United States on January 5, 2025
Works as expected of Dremel. I've purchased less expensive "equivalents" and found them lacking. These bits hold up well when used as directed and not allowed to overheat.
Glassman
Reviewed in the United Kingdom on January 25, 2025
Great.
Bilbar
Reviewed in Canada on September 18, 2024
These are durable little cutting bits and seem to hold their edge very well, outlasting the generic competition.
arthur deleon
Reviewed in the United States on August 8, 2024
Goog qualitu
Libor Chavez
Reviewed in the United States on April 23, 2024
Really like this burr for power carving wood with my dremel. Removes material quick. So far this burr has stayed sharp and have not had a problem with this bit.
Customer
Reviewed in Canada on April 17, 2024
like it
Bmax2
Reviewed in the United States on February 19, 2023
Bought the 2-pack assuming I would burn out one before completing my address sign before finishing. Carved out 5 numbers with a single bit in cedar at 3/16" depth and the bit is still sharp. Started at 30K rpm on the Dremel but found it burning a bit so finished the project between 15-20K rpm.Will buy these again if needed.
Customer
Reviewed in the United States on December 25, 2023
Purchased for an aluminum milling job honestly probably too big a job for a dremel, but they worked well. Pay attention to speed guidance, these will gum up with aluminum if you run the RPM too high. (12 to- max15K RPM works well) maybe overpriced, but a nich product and they will probably be around long enough for me to get value out of them
Hany E
Reviewed in Canada on November 8, 2023
Well made
Norbert Winkel
Reviewed in Germany on October 25, 2022
Modellbau.
Recommended Products
