Your cart is empty.
Your cart is empty.Original equipment brake lines are highly rust prone. This Dorman OE FIX brake hydraulic line kit is made of upgraded stainless steel to resist corrosion. It's also pre-formed to fit specific vehicle applications for easier installation. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chevrolet Silverado 2500 HD Classic: 2007] - [Chevrolet Silverado 2500 HD: 2003, 2004, 2005, 2006] - [GMC Sierra 2500 HD Classic: 2007] - [GMC Sierra 2500 HD: 2003, 2004, 2005, 2006]
MEL
Reviewed in the United States on August 13, 2024
These were a great fit
james bope
Reviewed in the United States on June 25, 2024
Advertised as a complete kit and was missing line from back of master cylinder to abs. Had to go-to town and purchase one, cost and inconvenience sucked. Not a complete kit
Ronald Schneider
Reviewed in the United States on June 1, 2024
This Dorman kit is nice. You won't be disappointed. I did a cab off restoration...installing these lines was a snap. Correct bends.
Mike
Reviewed in the United States on April 7, 2024
These made redoing the brake system in my truck a breeze the fitment is good and quality is good highly recommend this product
Gilles Boutet
Reviewed in Canada on August 29, 2023
Bonne informations pour l'utilisation
Mike Hunt
Reviewed in Canada on June 10, 2023
Been a mechanic for 50 years and always mde lines from scratch , wished we had these kits years ago
Customer
Reviewed in the United States on February 20, 2023
These are not 100% perfect, BUT for the price and time saved there totally worth it. I had a 2005 2500hd ext cab and I literally did the entire brake system in a couple of hours, go ahead and make it easy on yourself and pull the fender wells and start spraying your rubber hoses connection points with penetrating fluid now. I’ve messed with getting steel line from the parts store and the copper line as well. You won’t be disappointed and they’ll never rust out again. You may have to hand tweak them a tiny bit but that’s it.
John nichols
Reviewed in Canada on February 17, 2023
I bought a kit for my truck. One rear line was 1" short had to adjust the bends to stretch it. Two front lines the bends had to be adjusted. But I have working brakes.
Sean W
Reviewed in the United States on June 16, 2020
2003 GMC Sierra 2500hdPlowed for years in the snow with lots of surface rust, rotted out rocker panels the usual stuff but these lines were near too perfect almost exactly what I needed, and I was able to complete the project in one weekend. The most difficult part for me was the way my truck is set up with the gas tank I just had to lift up the bed so I can get the one over on that side of the frame rail other than that highly recommended.
Jordan Hakeman
Reviewed in Canada on June 19, 2017
This kit is for a extended cab short box although I installed it on a 2004 crew cab short box. The rear bracket that attaches the flex hose from the axle to the frame needs to be moved forward about 6 inches to work on a crew cab. Everything fit good except the line that runs over the gas tank was twisted about 90 degrees which just needed to be twisted back to make the corresponding bends work. Removing the drivers side inner fender and pulling the box makes for an easier install.
benoit st-hilaire
Reviewed in Canada on October 21, 2017
good product fast shipping easy to install
Endeavor to Persevere
Reviewed in the United States on July 25, 2016
Got these to replace the rusted out junk factory lines on my 2006 Silverado. The set was missing one of the lines that runs from master cylinder to the ABS block. I contacted Amazon and they sent me another set. I had also contacted Dorman and they were willing to might it right as well. You can't beat service like that. As for the lines. They fit very well. The longer lines are a bit of a struggle to get on. The one that goes from ABS block around the front of motor and to the front right wheel was a challenge. I actually haven't got the rear lines on yet. Those look to be the most difficult. A helper would make the job a lot easier. And I am not a real experienced mechanic. The stainless lines look great and should last longer than the rest of the truck. Why GM didn't put stainless on at the factory is one of life's mysteries. Probably would cost $20 per truck to go stainless versus the raw uncoated steel that they used in 2006.
seth schmidt
Reviewed in the United States on October 2, 2016
I had to replace all the brake lines on my 2004GMC Sierra 2500hd and this was so much better and faster than having to mark and bend all new lines. A few of the lines were a little long is the only reason they didn't get 5 stars. Other than that they were a nice product and made the pain in the neck job a little better.
Recommended Products
