Your cart is empty.
Your cart is empty.Hood release cable broken? This hood release cable is durably built to directly replace a worn-out or broken cable on specific vehicle years, makes and models. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Chevrolet Corvette: 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996]
inagibson
Reviewed in the United States on September 16, 2022
The cable couldn't be used. The cable was to short!
Nancy Dufner
Reviewed in the United States on June 5, 2022
This said it fit the vehicle we ordered it for which it does not. Had ordered this for a 1984 corvette and is way too long!
Joanne
Reviewed in Canada on August 28, 2021
Product was as expected
Samuel Santiago
Reviewed in the United States on January 14, 2021
Se utilizará en un corvette 1984 ya se instaló y funciona muy bien se recomienda el artículo.
leon d.
Reviewed in the United States on September 26, 2017
Working great
Derick Raven
Reviewed in the United States on September 26, 2017
Cable was too short like everyone else on here is saying. Don't buy this item! A lot of time and work to put these in to find out they are too short not impressed!
Joe R.
Reviewed in the United States on January 16, 2017
Fast shipping. Manufactured incorrectly. Had to customize the two ends at the hood latches.
Michael J. Hencin
Reviewed in the United States on April 23, 2017
The cable adjustment length was far too short. While the over all length of the cable on the driver side was adequate, the passenger side was just enough.I was able to lay the cable out but the threaded plastic adjustment sleeve did not have enough travel. I had to trim the threaded end on the cable jacket by about an inch to allow the adjustment sleeve to retract back far enough to slip into the clip and then also have the cable end snap into the actuator.I read many of the same stories on various forums but since I had the cable and felt confidant in trimming the end back I kept it. Trimming the end was non trivial. As you have to slowly snip away threaded end without clipping the strands of the cable.
Eric W.
Reviewed in the United States on July 27, 2016
Cable weren't the right length. Had to augment the casing to make it fit. Fortunately it was for a car that is being sold but other than that it is a complete fail.
Recommended Products
