Shopping Cart

Your cart is empty.

Your cart is empty.

Dorman 800-605 Transmission Line Connector With 3/8 Tube X 5/8-18 In. Thread Compatible with Select Models

Free shipping on orders over $29.99

$6.49

$ 2 .99 $2.99

In Stock

1.Size:1 Count (pack Of 2)


About this item

  • Quality replacement - this transmission cooler connector matches the fit and function of the original equipment connector
  • Durable construction - this oil cooler line connector is made of quality materials for a precise fit and leak-free durability
  • Performance tested - this connector has been rigorously pressure tested to ensure reliable performance
  • Ideal shop supply - this connector is recommended to have on hand any time service is being performed on the transmission oil cooler line
  • Ensure fit - Input your vehicle into the garage tool and check Confirmed Fit bar at the top of the page. If there is an ā€œiā€ in a blue circle, additional verification is needed. Please hover over the "i" to verify fitment notes match your vehicle.


Made of quality materials, this automatic transmission oil cooler line connector matches the fit and function of a damaged original equipment connector to restore leak-free performance between the transmission and the oil cooler.


False advertising
Reviewed in the United States on February 3, 2025
I ended up using these to add a transmission cooler to my 2014 GMC Sierra 1500. I did need to use a rubber washer inside because I was using a brass connector.
Earl Cordova
Reviewed in the United States on January 28, 2025
Doesn't work as well as the OEM version.
Alex
Reviewed in the United States on August 30, 2024
Leaked right out of the package. Replaced with an OEM and no issues.
sharon P shoch
Reviewed in the United States on July 29, 2024
Perfect
Fisherman
Reviewed in the United States on December 19, 2024
Worked out nice . Good value for the money
Eddystone
Reviewed in the United States on October 12, 2023
The Jiffy Clips holding transmission lines connected sometimes cannot be removed, even using the correct tool. I got three of the four clips on my lines off, but for the last I had to cut the pipe with a Dremel cutoff wheel and then remove this fitting from the radiator using a socket wrench. The factory fitting is extremely tight in the radiator and take a lot of force to unthread and remove from the radiator. However, with sufficient torque the fitting will come out without damaging the radiator. A LOT of torque to remove. These Dorman replacement fitting come with thread sealant already installed, and the thread right in easily. The standard GM transmission line metal pipes fit right in and seal properly. Note: It may not be obvious, but the Jiffy Clips are designed to not have to be removed. The removal tool fits around the pipe and spreads the clips without removing them. The pipe pulls out through the removal tool. To connect the pipe to the fitting, just push it in with the Jiffy Clip already in place. It will go in and lock.
Roxanne Maxson
Reviewed in the United States on April 5, 2023
Quality product worked right the first time.
Derrick
Reviewed in the United States on April 18, 2023
Works well and fit perfect