Your cart is empty.
Your cart is empty.Restore proper fuel gauge readings with Dorman's Fuel Tank Sending Unit. All units include the necessary installation hardware for a bolt- off/bolt on solution. Since this part is direct replacement, the exact fit adds another layer of convenience. Vehicle model years this part fits: Honda Odyssey: 2008, 2009, 2010
Peter Robberson
Reviewed in the United States on September 10, 2024
We like that this product is soft and pliable. All of the details lined up perfectly to replace the previous cracked intake.
Lop3z13
Reviewed in the United States on August 13, 2024
Fit perfectly
William O.
Reviewed in the United States on July 2, 2024
This part looks and works like OEM, and for a fraction of the price. Only took minutes to install, saved $200 from going to the dealership.
Wendy Bell
Reviewed in Canada on March 29, 2024
This part is half the price of the OEM (which doesn't include the clamps) and includes clamps which are equal to or better than OEM. It seems to be good quality rubber and has all the special alignment mouldings exactly as OEM. I sprayed penetrating fluid (Rust Check) the day before and disassembly was easy after I disconnected the air filter cover. Note you need to take the shroud off the engine to easily access the engine side clamp but that's only a half twist on two plastic screws. A dab of silicone lubricant on the new rubber and everything slide into place easily. Biggest challenge was disconnecting the small diameter metal tube on the side. I think it's part of the EGR system? It's inserted to a depth over an inch so you need to be cautious about not twisting too hard for removal. The two ends need to be free first to avoid pulling the small tube too far back and straining other joints. Only did a test drive so far, but set no codes, seems to be running smoother, didn't catch fire or explode. Two thumbs up. Honda dealer installed would have been close to $300, I took 45 minutes, got my hands dirty, fixed it myself and saved $250.
Sean
Reviewed in the United States on March 15, 2024
I had not one issue fitting this hose on my van. Slipped on relatively easy with some wiggling and clamps were all oriented the right way. Think it took 5 mins. Super easy replacement
T-rex
Reviewed in the United States on February 7, 2024
This air intake hose fit perfectly and went on just like OEM, but at a fraction of the cost.
Maksi Maksi
Reviewed in the United States on December 4, 2024
Super
greg wright-crowe
Reviewed in the United States on October 27, 2024
just like OEM
Thanh B
Reviewed in Canada on June 25, 2023
Bought it for my 2008 honda Odyssey, working great. Only thing is the clamp faces the other way, i reused my old clamp
ruq2011
Reviewed in Canada on March 31, 2023
Perfect fit for my 2010 honda odyssey just like the oem, the clamps in the right way all Good.
carlos
Reviewed in Canada on November 2, 2023
I installed it on my 2010 Honda Odyssey. Easy to install and fit perfectly.
Scott Mattaliano
Reviewed in the United States on September 23, 2022
If you use clamps it comes with it makes tightening the clamp at the throttle body difficult. The clamp is keyed so you can't just flip it to correct. Not really a big deal but extra work if you bury the fastener behind the intake.Perfect fit super easy to install. maybe 3 minutes for myself..average person 5-10 minutes.
Jaykumar
Reviewed in Canada on December 19, 2022
Ok quality but value for money
Recommended Products