Your cart is empty.
Your cart is empty.This suspension control arm bumper is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.
ernie elliott
Reviewed in the United States on March 3, 2025
they work
James P
Reviewed in the United States on January 2, 2025
Product was an easy swap, and has held up well since purchase
George Robards
Reviewed in the United States on June 21, 2023
I ordered a set of these at the same time. For what ever reason, one was shipped via prime and the other USPS. WTF. At any rate, the part was correct.I raised the truck using a floor jack under the lower control arm, raising the truck just enough remove the tire/wheel. Used a 9/16 ratchet box end. Took maybe 5 minutes tops. If you raise the truck via a frame lift, the upper control arm may block your access to the bumper's nut. Pretty easy, just take your time.
RC1057
Reviewed in the United States on November 17, 2023
Fit perfectly and looks durable.
James wubbolt
Reviewed in Canada on May 11, 2022
Perfect fit
Chris
Reviewed in the United States on March 14, 2021
Good part but the alignment tab that is punched out isn’t very precise and needs adjustment to fit the control arm. Had to send one back because it was so badly done it couldn’t be adjusted. Easy swap out from Amazon though.
Yannick Brouillard
Reviewed in Canada on February 10, 2021
Good
KatsRule
Reviewed in the United States on September 5, 2020
This product worked well, but as in other reviews they stated they had to adjust the pinthat hold it in place while you tighten the nut.There is a small pin punched into the top to assure the product does not spin while tightening the nut,and the pin is a bit slumped over, not straight up and down.. I too had to take a large screwdriver and a hammer to straighten the pin, but it was a very small task, and the product then fit perfectly.Easy to install, in an easier access part of the A Frame on the top A Frame, just reach in and unboltthe old one, and slip in the new one....all this after taking the tire off as well before you start .Great product.
Tommy ross
Reviewed in Canada on September 12, 2020
Excellente qualité de pièces va a merveille
Craz Cdn
Reviewed in Canada on June 20, 2020
Fits well like it should
levis lefebvre
Reviewed in Canada on December 4, 2019
perfect fit
JON PATZER
Reviewed in the United States on April 16, 2017
These will hopefully be an improvement in durability oven the originals. A problem for my vehicle was that the locating tab was not quite perpendicular and fell a little short of the factory mounting slot. Bending the tab up a little farther allowed it to fit.
Brandon Nierenhausen
Reviewed in the United States on September 12, 2016
These are fantastic. The ones on my 2000 Bravada were almost completely destroyed. When i installed these they made a huge difference over bumps it was awesome! The only negative was trying to install them. If you want to make it easier just pull old bumper out on the vehicle using a screw driver but leave the frame it was in bolted to the vehicle. Then just pull the new bumper out of its frame and lube it a little bit and slide it in the old frame that is already on the vehicle. It takes a little elbow grease but they will fit.
Recommended Products
