Your cart is empty.
Your cart is empty.
Compatible models:
◆ Dock Connector/Charging Port Replacement Flex Cable Compatible with iPad Air 2013 A1474 A1475
◆ Dock Connector/Charging Port Replacement Flex Cable Compatible with iPad 5 5th Gen 9.7 inch 2017 A1822 A1823
◆ Dock Connector/Charging Port Replacement Flex Cable Compatible with iPad 6 6th Gen 2018 9.7 inch A1893 A1954
Package Contents:
◆ 1 * Charging Port Replacement Flex Cable
★★★★★
◆ For any inquiries regarding the product or service, please contact us and we will do our best to solve your problem within 24 Hours.
◆ We are very grateful for your suggestions, which will help us serve you well.Thank you for your co-operation.
◆ Thank you for shopping in our store!
★★★★★
i love it
Reviewed in the United States on February 17, 2025
waste of time I messed up my connectors
Ernesto GJ
Reviewed in the United States on August 4, 2024
Buena calidad aunq necesitas tener algo más de experiencia para cambiar esta parte fue un trabajo de 2 hrs
T
Reviewed in the United States on April 8, 2024
Not a job for me. I should’ve sent it back but forgot to do so. You will probably have to have a professional install this as it requires some soldering on a massive amount of pins.
Lyudmila Nikolayev (Kruts)
Reviewed in the United States on August 29, 2023
Everything was good
John M
Reviewed in the United States on December 21, 2023
I needed to replace my wife's ipad lightning port due to becoming intermittent. This product was really the only inexpensive way to solve it short of buying a whole new iPad or Logic board assembly. The part shipped was marked as: 821-1360-A on the assembly, where the part in the iPad was: 821-1716-A. After a little search work, I found that the 1360 is a compatible assembly. After disassembling most of the iPad using iFixit website instructions, and removing the logic board, I then followed a youtube video "iPad 5 Charging Port Replacement" from Kabonster who did an excellent job of detailing the work needed to remove the old flex circuit from the logic board and aligning and soldering the new. You need a Hot Air workstation set to 400C, lots of flux, low temp solder paste, and alcohol wipes. You will likely need a 40-80 power stereo-optic microscope to ensure proper alignment and soldering of the extremely small pads. All told it took me about an hour and half to accomplish the task. This job requires A LOT of Patience, so please be warned, if you don't have a steady hand as well as patience, let someone else do the work for you. I hope this helps.
Queith
Reviewed in the United States on October 5, 2022
Bought as a gift to someone
Solomon
Reviewed in the United States on September 8, 2021
I charged my iPad Air first gen A1474 twice no Issues.
Gary Y
Reviewed in the United States on October 14, 2021
My charging port was bad and this is a good replacement. Just know that this does not have a snap on connector. You have to remove the solder on the old one and solder this one on. If you can't solder small connections, pay to have it done.
Recommended Products
