Your cart is empty.
Your cart is empty.Product Description
Pins:
- VM: Driving Voltage Input(4.5-10V)
- VCC: Logic Level Input(2.7-5.5V)
- GND: Ground
- PWMx: Connects to the PWM port of the MCU
- A01 A02: Connect to Motor 1
- B01 B02: Connect to Motor 2
TB6612FNG Motor Driver:
Specification:
- Power supply voltage: VM=15V max, VCC=2.7-5.5V
- Output current: Iout=1.2A(average) / 3.2A (peak)
- Standby control to save power
- CW/CCW/short brake/stop motor control modes
- Built-in thermal shutdown circuit and low voltage detecting circuit
- All pins of the TB6612FNG broken out to 0.1″ spaced pins
- Filtering capacitors on both supply lines
Features:
- The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes – CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode.CJMCU.
- Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
- Board comes with all components installed as shown. Decoupling capacitors are included on both supply lines. All pins of the TB6612FNG are broken out to two 0.1″ pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.
Sheldon S.
Reviewed in the United States on February 18, 2025
I needed three of these for the six-wheeled rover robot I was building so this worked out great. They are dual stepper so each board can control two motors. I started out using the L298N but they were so inefficient and these TB6612FNG were so efficient and smaller so glad I picked these. Documentation is easy to find, and they are a great value too! I used the SparkFun Arduino Library for them.
Gary P.
Reviewed in the United States on July 11, 2024
I haven't had any issues with this board. It runs motors just fine off my Arduino.
Watermelon
Reviewed in the United States on January 30, 2024
This is a great motor driver. It is very easy to use once you assemble it. I wish it came pre-assembled but I like the set for the price. I did not mind doing the solder work. I then installed it on a prototype board. No issues and happy with the purchase. Product works as advertised.
Stuarta670
Reviewed in the United States on December 6, 2023
They are perfect for a project I'm working on. Plus a three pack was a great deal.
Recommended Products
$10.75
$ 5 .99 $5.99
$299.99
$ 99 .00 $99.00