Bought this blade to cut some maple boards. My old blade was really struggling, a lot of tear out and some burning, even after cleaning. The DW3219PT blade went through the maple very efficiently. Cuts were precise. No smoke.

Nice clean cuts on melamine which is what I bought it for.

Après avoir regardé de nombreux commentaires sur différentes lames afin de trouver la bonne lame pour couper des rampes en aluminium, j'ai décidé d'y aller avec la DEWALT DW3219PT: des coupes parfaites du premier au dernier morceau!Je n'ai aucun commentaire négatif au sujet de cette lame; elle fait le travail annoncé et de façon nette et précise. Je n'hésiterai certainement pas à faire confiance aux lames Dewalt pour mes besoins futurs de coupe.

Gee l wish l'd purchased it years ago. I've only used it a dozen times but it cuts perfectly with very little tear out at the back. 80 teeth really makes a difference over my regular 60 tooth blade (which was also a good brand) but the Dewalt is much better especially with finer mouldings.

Worked very well. Perfect and provided crisp clean cuts for baseboard install. Over 4500 linear feet and still sharp as when purchased.

I needed to cut board that had a thin, hard laminate on it and I didn't want it to chip. This blade did excellent job!

This blade is excellent. I have used it to cut through a variety of materials. The blade does well with little tear out. I cleanly cuts through both wood and plexiglass. This is the second blade I have purchased. The first blade has lasted over two years. I would highly recommend this blade based on its quality and durability.

I'm a dewalt man so I'm a bit biased. Out of a workshop full of mostly dewalt tools in the twenties year I've been buying I've had exactly one bad tool and that was quickly exchanged without problems. This saw blade is to me a great general purpose blade , in saying that there are more expensive blades that may cut better for the purpose you wish to use them. I even have a couple used for specialty cuts only..this is a fine thin kerf blade at a fair price..like other high end brands you do pay something for the name but most times if used on a regular basis it more then makes up for it longevity.

So far this blade has been great for my needs in my mitre saw. very clean cuts

It makes a really nice and clean cut on my table saw. Some say 80T is too much and you can do 60T with almost the same effect. I guess it depends on what you what to achieve and you kind of work.Anyway, I like it and hopefully it will last longer than people usually say it lasts. ( not much )

Works as expected. More teeth, better cuts.

I am putting a new kitchen in for my wife. Much cutting on hard wood. Flooring, baseboard, cabinet trim. The blade is doing great, o have one in my chop saw, and one on my table saw. I am getting veryyyy fine cuts. I am very happy.

I purchased this blade due to the (-5) pitch angle, which provides a "premium cutout" for my compound slider miter saw. If you watch for promotional price breaks from Dewalt the price comes in-line with the competition. I use this blade for the multitude of MDF moldings available. The (-5) pitch angle seems to provide the cleanest cut lines I have found. This blade incorporates the TCG tooth design, which is useful when cutting the multitude of PVC trim stock and mouldings.