Your cart is empty.
Your cart is empty.Denso Oxygen Sensor - 234-4524
Arie
Reviewed in the United States on May 21, 2025
Perfect for upstream sensor on ‘06 Scion XB
Teodoro Galvez
Reviewed in the United States on May 3, 2024
Perfect fit and resolved the issue with my car.
Carp
Reviewed in the United States on May 28, 2024
Oem is the best
Maurice May
Reviewed in Canada on September 18, 2023
Believe sensor is not the correct upstream sensor for the car. Ordered and installed different sensor and it worked fine.
T .R
Reviewed in the United States on December 6, 2023
Not good
GH
Reviewed in the United States on November 16, 2023
I always use Denso. Absolute quality. Perfect Fit for my 2006 Scion XB. You will need a 22MM socket to install it. It already comes with Anti-seize installed !! Replacing both the front and rear O2 sensor my car now gets 3.56 mpg better per gallon of gas.
Aaron
Reviewed in the United States on September 11, 2021
The easiest o2 install I have ever done. The hardest part was disconnecting the plug and it wasn't difficult. Original toyota stamped o2 sensor came out of an 06 with 190k miles. I don't expect it to last that long but cheaper than autozone and an easy job. Downstream was not changed wires are tucked away so take a look first if you're going to do it.
Carlos B.
Reviewed in the United States on April 22, 2020
Excellent product, Fixed 2 codes on a 2006 Scion XA. Codes P0133 and P0134.I replaced both oxygen sensors on the vehicle with parts, DENSO 2344524 (upstream) and DENSO 2344069 (downstream)It is very easy to replace. It was probably more work to raise the vehicle off the ground with enough clearance to get underneath and work.Before the replacements, the car ran sluggish and consumed way too much fuel.. After the replacements, it runs at ease and consumes little to no fuel for a 60 mile trip and codes are now gone.
crispybacon
Reviewed in the United States on December 8, 2015
Had the check engine, track off, vsc light. Ran OBD scan and received codes P0456, P0442, P0456 MIL ON MONITRS 0 INC 7 READY MISFIRE FUEL Comp Catlyst Evap O2 Snsr O2 Htr. Replaced O2 sensor with this item on my 2004 Scion XB and the lights went off and no codes.It was a royal pain to remove it, so make sure to brush off any rust with a wire brush and use WD40. Heat up and cool down several times to loosen. Make sure to use threaded socket as it will be night and day without this tool.This item also includes Nickel Anti-Seize Lubricant, so no need to buy any.
Recommended Products
