Your cart is empty.
Your cart is empty.Product Description
Linear Ball Bearing Motion Slide Units
Grease may be applied prior to use to improve smoothness.
Maintain lubrication of optical shafts and guides during operation.
The recommended load is 80% of the rated load, exceeding the rated load will affect fluidity.
The table needs to be level during installation, otherwise it will interfere with installation calibration.
Require regular cleaning and maintenance.
SBR20UU Aluminum Slide Block is a 20 mm ball bearing slide block for the Industrial UUU series slide bearings.
Size - Shaft diameter: 20mm. Overall size: 1.9” x 2” x 1.5”
- Inner diamter: 20mm ( LM20UUOP)
- Material:Aluminium Alloy & Ball Bearing Steel
- Quantity:4pcs
- Color:Silver
This Slide Block is fit for SBR20 20mm Linear Guide Rail. Great for use with both linear and rotary sliders. With its aluminum construction, it can be used with a variety of materials and provides an easy way to install the rail. It fits on the guide rail and locks in place in just seconds.
bill lea
Reviewed in the United States on September 30, 2024
the bearings were therer but no rails
Kelly
Reviewed in the United States on March 20, 2024
Used as a slide carriage bearing for router sled
Michael Earwood
Reviewed in the United States on August 19, 2023
Well made and easily installed. The four mounting points on the top are great to use to mount. They are light weight and should last quite a while. I also purchased the rail to make a complete system.
Jeremy I Menard
Reviewed in the United States on January 22, 2023
Good quality product. Would definitely buy again.
L&S
Reviewed in the United States on September 13, 2022
9/13/22So far so good... have only had them for a few days. So this is a short term evaluation.The fit and finish is industrially good. The fit is exceptional on my existing 20mm round rails very happy with the product. One more step fwd to my DIY cnc project
Dave Evers
Reviewed in the United States on August 30, 2022
Great bearings to use with 20mm rods for linear motion. You will want to look for hard-chrome plating in any rod you use - otherwise the bearings will wear a track into the surface. Also look for supported rails with a T-type mounting facility that these bearings are designed around. 20mm round rod will not be straight over more than about 1 meter without support.
Clayton
Reviewed in the United States on October 10, 2022
I used them for my diy router table, they work great
Customer
Reviewed in the United States on October 10, 2022
These blocks are excellent quality. Importantly, Am the entire set is the same size. The construction of the blocks is also superb. I don’t see anyone going wrong choosing these blocks.
Recommended Products