Your cart is empty.
Your cart is empty. Applications
The anchor is made from Zamac Alloy. This anchor is designed for use in Concrete, Block, and Brick.
Environment
The anchor is designed for use in a Wet environment.
Hole Diameter/Bit Diameter
The anchor requires a 7/8" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Minimum Embedment
The minimum anchor embedment into the concrete is 3-1/2". Therefore, the anchor must be installed so that a minimum of 3-1/2" of the anchor is embedded into the concrete.
Spacing between Anchors
Each anchor must be spaced a minimum distance of 8-3/4" from each other when measured center to center.
Edge Distance
It is very important not to install the anchor any closer than 4-3/8" from an unsupported edge of the concrete.
yateselect
Reviewed in the United States on January 28, 2022
This product performs as expected, using for utility eye bolts to hold overhead service drops up
James C. Diquattro
Reviewed in the United States on September 23, 2021
I'm using 10 of these with 10 -10" bolts (with the heads cut off) on my fireplace to mount a 9 foot 250 pound beam for a mantel. These worked great!
PT
Reviewed in the United States on November 13, 2020
I ordered these anchors to hold the hinges for a gate attached to a cinder block fence. The size, 5/8th inch, seems unique. I was glad to find them on Amazon. Concrete Fasteners provided the exact product I needed and shipped it promptly. It arrived within 3 days securely packaged. They even specified the bit size required to set these anchors. Perfect product and service. Thank you Dave and Mike in Ohio.
Recommended Products
$58.46
$ 27 .99 $27.99
$63.99
$ 30 .99 $30.99
$15.00
$ 6 .99 $6.99
$51.26
$ 26 .99 $26.99