Your cart is empty.
Your cart is empty. Applications
The anchor is made from 304 Stainless Steel. This anchor is designed for use in Concrete, Block, and Brick.
Environment
The anchor is designed for use in a Wet environment.
Head Style
The anchor is a Hex head and is designed to allow the head to sit on top of the surface of the item being attached.
Hole Diameter/Bit Diameter
The anchor requires a 3/8" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Diameter of Anchor
The diameter of the anchor is 3/8".
Length Anchor
The length of the anchor is 3"
Minimum Embedment
The minimum anchor embedment into the concrete is 1-1/4". Therefore, the anchor must be installed so that a minimum of 1-1/4" of the anchor is embedded into the concrete.
Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-3/4". This will ensure that the minimum embedment of 1-1/4" will be met.
Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/8" diameter anchor requires the hole in the fixture to be 1/2".
Spacing between Anchors
Each anchor must be spaced a minimum distance of 3-3/4" from each other when measured center to center.
Edge Distance
It is very important not to install the anchor any closer than 1-7/8" from an unsupported edge of the concrete.
Nick
Reviewed in the United States on February 22, 2024
Threads strip instantly, wrong nut bolt combo, blew through 20 and only got 4 to actually work. Didn’t matter what I did, wouldn’t set. My customer loves the extra 5 cut off anchors in the concrete for no other reason than a fault anchor. Very unhappy.
mark rodgers
Reviewed in the United States on November 16, 2023
The product was not as shown in photo. I am returning.
Hybrid traveller
Reviewed in the United States on August 17, 2022
Bought these to anchor aluminum posts for a privacy screen to my concrete slab patio. The posts are weather exposed, including to snow in the winter. I wanted something that was easy to use, secure and weather resistant. These concrete sleeve anchors were a breeze to insert and tighten with the hex nut. Key is to use a quality hammer drill and masonry bit. I used a Dewalt drill and Bosch 3/8 inch carbide bit. Easy enough to drill, suck out the dust as you go, drill about 1/4” deeper than the sleeve anchor. Gently tap in with a hammer and tighten the hex nut. Seems very secure and sturdy but I’m waiting for some serious wind to give a final verdict!Confast were awesome to deal with and even followed up to check if everything was good with the delivery!
recycleman
Reviewed in the United States on July 25, 2021
Measure your hole carefully to ensure the height is correct. The fastener locks in quickly and is very secure.
George M. Kasper
Reviewed in the United States on November 3, 2021
Work as expected!
Recommended Products
