Your cart is empty.
Your cart is empty. Applications
The anchor is made from Zamac Alloy. This anchor is designed for use in Concrete, Block, and Brick.
Environment
The anchor is designed for use in a Wet environment.
Hole Diameter/Bit Diameter
The anchor requires a 3/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Minimum Embedment
The minimum anchor embedment into the concrete is 3". Therefore, the anchor must be installed so that a minimum of 3" of the anchor is embedded into the concrete.
Spacing between Anchors
Each anchor must be spaced a minimum distance of 7-1/2" from each other when measured center to center.
Edge Distance
It is very important not to install the anchor any closer than 3-3/4" from an unsupported edge of the concrete.
Roger D. Goff
Reviewed in the United States on February 10, 2025
Good price fast shipping excellent seller
tom
Reviewed in the United States on October 17, 2019
I have used this type of anchor for years and it has worked well for me when using this product in concrete .I would like to say that the company that carries this product has provided a indepth description of the products it sells and was very helpful when I needed technical information about anchors. This information is what I expect when purchasing from an Amazon seller.
Recommended Products
$63.99
$ 30 .99 $30.99
$28.99
$ 14 .99 $14.99