Your cart is empty.
Your cart is empty.
Co2 Laser red dot position
12 different sizes available.
Please select a size from the drop down menu.
For the "APC" K40 head upgrade use the 25mm red dot positioner.
For the APC 4" focal length lens tube use the 25mm red dot positioner.
Noah
Reviewed in the United States on March 3, 2023
Most of the listing images except for one, are too poor quality to clearly indicate that these are actually just 3D-printed parts. The description also neglects to inform you on what exact material it is made from, but I suspect it may be PETG (hopefully). When I took mine out of the box, the bracket had horrible voids and layer artifacts around the ear where the bolt squeezes and I am not so sure it will stand the test of time.In addition to this, testing the diode with 5 volts showed it was dead. I double-checked I had the right polarity and it was just DOA. All around a disappointment since I could have made my own but was looking to not spend the time.
M. Ross
Reviewed in the United States on March 13, 2023
Ordered two sizes a while ago and the wire was so thin I had to find a suitable connector and tossed them in a drawer until I had time to deal with them. Fast forward to more recently I found connectors I would be happy with and had them mounted on the appropriate sized lenses for maybe a month or two. The 3D printed parts split perpendicular to the print direction which indicates the dimensions are poorly calibrated. Stress fractures have made these un-useable. My only recourse is to re-order which I refuse to do at the price I paid for these vs. the nickel of plastic they are made of. Emailed Lou and due to the time from my order they have refused to offer any support even though this is clearly a manufacturing defect.Likely will design and print my own on my own 3D Printer, I was just hoping to avoid a lot of time when I paid for a product that was supposed work. Not everyone would have this capability.Very disappointing that both failed in the same way in a short period of time. Will strongly consider wether or not to purchase from AP again.
cliffs56
Reviewed in the United States on April 13, 2023
I bought this to fit on my APC laser lens which is 18mm but the piece is too large and doesn't tighten. I jerry-rigged in by wrapping electrical tape around the lens tube. The red light also is very big rather than a pin point. APC is not doing a good job here.
Recommended Products
