Your cart is empty.
Your cart is empty.Product Description
CNC Router Bits 1/8" Shank CNC Bit End Mill
Flat Nose Carbide Endmill Two Flute Spiral Upcut Milling Cutter Tool
- Flat Top with 2-Flute, Material: HRC55 Carbide
- For CNC, Engraving Machine.Carbon Steel, Mould Steel, Inconel, Stainless Steel, Titanium Alloy etc;
- The Route Bit Suit for CNC Router and Makita, Bosch, and Any Brand Plunge Router with 1/8" Collet;
- End Mill Bits are Suitable for Side Milling, End Milling, Finish Machining, etc.;
Solid Carbide Spiral Upcut Bits
2 Flute Design
- Fast Chip Removal .
- Smooth Cutting.
- Sharp-edge pattern allows faster engraving operation with higher efficiency.
- Fits for woodworking engraving machine, advertising CNC router machine.
Larger Spiral Chip Space
The design of flutes, larger spiral chip space of CNC Router Bit makes non-stick crumbs, smooth cutting and fast chip-removal. Durable, high precision and not easy to break; it is smokeless and no burr while processing.
Rounded Corner Design
Easy to install
Carbide Material
- Not easy to break.
- This set of solid carbide milling cutter is ideal replacements for your CNC machinery, making you enjoy a precise and easy cutting experience.
Practical Package
Bits are well assorted in a plastic case for easy storage.
Each contained in a individual section, with a foam inserted keeping the bits from beating each other up.
Customer
Reviewed in the United States on January 7, 2025
I have already broke 3 of these in the first week of use. 1 was my fault, but it broke easier than I would imagine. The size was as specified and fit in the collet of my dewalt
CB
Reviewed in the United States on September 21, 2024
They work for what I need to try out different materials. I doubt they will last but I recommend
Customer
Reviewed in the United States on August 6, 2024
I figured that because they are cheaper that the quality wouldn’t be as good as a more expensive bit but I thought I would give them a try. I was using a better quality bit for this project I was working on and ran my CNC at a good rate. I figured I would dial back my CNC to make sure not to break the bits. I brought 3 before I could even finish the project. I slowed my CNC way back and they still broke. It would be more worth it to buy a more expensive bit.
Dale
Reviewed in the United States on June 9, 2024
Works great on my X-CARVER
Rob
Reviewed in Canada on June 28, 2024
Don’t know if I got a bad batch or what. But broke 4 within seconds of touching wood: small shallow passes in a softer hardwood (wormy maple) at 0.5mm depth per pass. Worked okay-ish is balsa wood.
B
Reviewed in Canada on June 26, 2024
I've spent a few hours cutting Baltic birch plywood with one of these and it's still going strong. No broken bits. These will be my go to bits for ½" or thinner wood from now on.
Justin Richardson
Reviewed in the United States on February 26, 2024
Stood up to 1/4” birch ply with no problem.
Bob
Reviewed in the United States on December 7, 2024
Any bit this small is fragile, however, they seem to stay sharp for a reasonable amount of time.
MS
Reviewed in the United States on October 24, 2024
They are inexpensive and work just fine.
Teknoray
Reviewed in the United States on April 15, 2024
I’ve used it several times now and it stays sharp. I wil buy them again.
Recommended Products