Your cart is empty.
Your cart is empty.Product Description
Equipped with Four Adapters
Small and Large Size Adapters: Compatible with fuel injectors on most cars and motorcycles.
Medium Size Adapter: Compatible with VW and Audi vehicles.
Adapter with Threaded Hole: Compatible with BMW N series vehicles.
Wide Compatibility:
1. The fuel injector cleaning kit works with any fuel pressure tester.
2. This fuel injector test kit can be modified for relay testing or solenoid valve testing, and other modifications should be carried out under the guidance of professionals.
8 Pulse Modes (Mode 1 - Mode 8)
Mode 0: Standby State, no output
Mode 1 (Single Pulse Low Power Mode) and Mode 5 (Single Pulse High Power Mode): the fuel injector tester will send out a pulse with a pulse width of about 255 milliseconds.
Mode 2 (Short Pulse Low Power Mode) and Mode 6 (Short Pulse High Power Mode): the fuel injector tester will send out 50 pulses with a pulse width of about 7 milliseconds.
Mode 3 (Long Pulse Low Power Mode) and Mode 7 (Long Pulse High Power Mode): the fuel injector tester will send out 100 pulses, and the pulse width is about 3.5 milliseconds.
Mode 4 (Continuous Pulse Low Power Mode) and Mode 8 (Continuous Pulse High Power Mode): the fuel injector tester will output pulses continuously, the pulse rate is about 50 pulses every 1450 milliseconds, and the pulse width is about 7 milliseconds.
Easy-To-Operate Fuel Injector Tester Pulse Tool
- Turn off the car engine.
- Remove the wire plug of the vehicle injector to be tested, then connect the red pulse output terminal of the fuel injector tester tool to the positive pole of the fuel injector, and the black pulse output terminal to the negative pole of the fuel injector.
- Connect the red clip of the fuel injector tester cleaner to the positive terminal of the 12V car battery, and connect the black clip to the negative terminal of the battery.
- Press the "MODE SET" key to select the desired pulse signal output mode, and the screen will display the currently selected mode.
- After selecting the desired pulse signal output mode, press the "PULSE" key, the fuel injection cleaner will output pulses to the automotive injector to be tested, and the signal indicator will light up when the pulses are output.
- After the test is completed, if you need to repeat the test, you can press the "PULSE" button again. If you want to change the pulse mode, you need to disconnect the battery of the fuel injector cleaner tool and then reconnect it.
Product Details:
Alligator Clip: The clip with strong bite force is not easy to fall off, providing you with a better experience.
Four Pulse Output Terminals: You can use it to test each injector individually, or both injectors at the same time
DC Input Port: Powered by 12V battery or DC 12V (recommended 2A) power adapter
akupnt
Reviewed in the United States on February 23, 2025
I had an issue with the tool. CMTool contacted me for a resolution. Recommended seller.
Arnaldo Grant
Reviewed in the United States on January 15, 2025
Works well…. I’ve no problem with it.
Prince Ringo
Reviewed in the United States on September 5, 2024
The instruction manual for useing the tool was vague in that after it told how to press the buttons, for the long pulse, short pulse, etc, it didn't tell you what to look for to determine whether the injector was working or not.Fortunately, by replacing the injector wiring harness, the cr runs great.
Thomas
Reviewed in the United States on September 12, 2024
The fuel injector cleaner worked perfectly. I didn’t try doing 2 injectors at a time. I liked that the kit included everything needed to test the injectors in a nice carrying case.
K. Lee
Reviewed in the United States on June 25, 2024
Worked great and easy to use. Cleaned up four fuel injectors on my BMW K1200S. Wrapped a bit of electrical tape around the straw on my can of carb cleaner spray to seal with the tube assembly that the injector mounts into
QN
Reviewed in the United States on March 27, 2024
It sprayed messy to the bottom. I used whole can of cleaner but injector was still no spray good. The plastic control box is melted by the cleaner liquid.2 Do Not buy.
Roland Arias
Reviewed in the United States on February 22, 2024
So if you have an Audi BMW and you're doing the dreaded carbon cleaning this is a great pick to also drop out your injectors and keep them in pace with everything you're doing if you're cleaning your valves you might as well also clean your injectors and this is super easy to do even for someone without experience. Definitely make sure you get all the right holders for all injector types mine didn't come with the VW/Audi one they replaced it quickly and was able to test injector pattern and clean the injectors right away without having to pay an arm and a leg, do yourself a favor and pick up a tool you could use over and over with multiple project.
Matthew
Reviewed in Australia on November 5, 2024
Adapters are fine but the electronic box is pretty hit and miss, works 1 out of 10 times, constantly have to turn it off and on to try to get it to work
Ozone
Reviewed in the United States on November 27, 2024
Product works as advertised would be great if it came with new filters but it definitely tests and cleans injectors...lots of money saved...
Recommended Products