Your cart is empty.
Your cart is empty.Intensive cleaning for the catalytic converter, this kit includes two products, one goes in the gasoline tank and the other foam cleaner spray directly on the catalyst from the O2 sensor port. high quality new technology design by the leaders in this industry. we always advise to inspect the catalyst from any cracks, before using the cleaner. ADVANTAGES - Removes existing deposits - Provides protection against heavy dirt with regular use - Provides the engine performance Restores - Ensuring the proper operation of the catalytic converter / turbocharger and the EGR valve - Product properties: For use in all petrol and diesel engines and hybrid vehicles.
Tracy
Reviewed in the United States on March 2, 2025
Decided to try this on a 2019 Jeep Wrangler with the 2 liter turbo motor, got the dreaded catalytic converter light, followed the instructions…light went off the next day and hasn’t come back, a little over 5000 miles and it’s still off!! Will be getting two more to use in my twin turbo truck for a little peace of mind
Gabriella Broomhall
Reviewed in the United States on February 26, 2025
Amazing stuff. Worked wonders. saved me so much money
T. Ingrim
Reviewed in the United States on July 29, 2024
Frustrating issue caused by the failure of the Kia 2.4L motor in a 2017 Sorento. Kia makes you drive for >2000 miles under the pretense of an oil consumption test. As my car accumulated miles and burnt through quart after quart of oil, the engine light came on. P0420 - Kia will not repair that failure their testing causes - but tell you that upon driving afterwards it MAY clear out. After burning a total ~8 quarts of oil during the discovery of the failure and the oil consumption test, waiting for 4 months as Kia changed the motor, and driving for several thousand miles - I had changed out the upper and lower O2 sensors and was pouring many different catalytic clearer gas additives without success. My Sorento's NONCONTINUOUS monitoring Catalyst monitoring test would run between 1.19 and 1.57 (with a limit of .9995). I then tried this foam cleaner that immediately dropped the ratio to 0.78. Now the fault codes are staying off and are not reappearing after resetting and 40 minutes of drive time. I was worried that the foam cleaner would be complicated and messy. It was way easier than I imagined and I am a very big fan. I was very close to accepting my catalytic converter would need replacing, I was wrong. Best wishes in your endeavor.
B. Blank
Reviewed in the United States on June 5, 2024
I have a 2013 Infiniti JX35 and have intermittent P0420 code that came on with a vengeance right when I needed a smog test. It is crazy expensive to replace a catalytic converter for this model so I was looking for other options.I changed the O2 sensors...no luck! I put an additive in the fuel tank...no luck! I tried spraying Gunk foam carb cleaner in the upsteam hole to clean it out...it worked for a minute, then CEL!I was looking for a foaming cleaner and came across this product. I crawled back under the car and started spraying in the upstream sensor hole. It would foam up and out of the hole, so I sprayed it in small amounts and then gave it a few minutes to work its magic. Lather, rinse, repeat.The chemical doesn't smell like other strong solvents and has a pleasant orange smell. The runoff cleared oil and grime away, so I knew it was working. I let it sit for about 30 minutes, installed the O2 sensor and added the sensor cleaner to the gas tank, then took off for a long drive. There was minimal smoke, and I noticed improved performance. It did trigger the CEL once, but I cleared and it drove it a bit to see if it came back...it didn't. The next day I took it to smog and it passed! Yay! Lots of stress off my shoulders.
Customer
Reviewed in the United States on June 15, 2024
Been struggling with a check engine light. I have tried 3 different fuel ⛽️ additives to clean the catalytic converter (these products are expensive 💰). I also replaced the sensors, thinking that may be the problem. None of this worked. So went to buckys muffler they wanted over $3000 to replace the catalytic converter. Then I found this product 👁 I think on YouTube🤔. Unbelievably easy to use and it worked first try I actually bought 2 kits. Going to use the other one on another car. I dont care about packaging but It is nice 🏆. Product came with everything needed... even a funnel for the tank/fuel treatment. Clear instructions on both cans. And worked 💯 first try🤯💊. Very happy highly recomen!!.💯🤑👌🤠
Jo murphy
Reviewed in the United States on November 17, 2024
Not only did it not work instead of just P420 code like it was when I started now is 6 codes. Even 4 brand new o2 sensors now it says they are bad products suck and messed vehicle up worst than it was don't waste your time and money
Robert
Reviewed in the United States on April 6, 2024
Have a 2007 Camry (220K miles ) which burns 1 qt. oil every 3000 miles and has an oil fouled main catalytic converter with about 50% blockage as viewed through my fiber-optic close up camera through the top O2 sensor port hole. After following instructions and using product 3 times I can say it does NOTHING to clear clogged mesh of the catalytic converter. Car runs great, however 420 code is still tripped even with New 2nd catalytic converter, 2 new Factory dealer O2 sensors , new dealer water Temp. sensor and new exhaust system. The main clogged catalytic converter is not damaged or overheated AT ALL however 50% of holes are clogged ( clearly seen on TV monitor ) and this product did NOTHING at all to clear any of them. OK for light carbon build up but way too expensive for that purpose. Will now have to spring for new converter at 1K plus. Manufacturer should REFUND my money!!!
RR50
Reviewed in the United States on November 11, 2022
Products were easy to use and did a good job cleaning my DPF filter. Used two units to clean it out thoroughly.
Recommended Products