Your cart is empty.
Your cart is empty.Product Description
- Filter Rating 10 Micron.10 micron filters are over 90% efficient at removing particles as small as 10 microns.
- 10 micron filters are recommended to prevent damage to sensitive inboard, sterndrive and outboard fuel injection systems, Designed to trap the smallest particles and emulsified water from Diesel.
- These are more suited to compact off road diesel equipment:tractors,skid steers loaders,movers.
Fuel Filter Water Separator
Features:
- The filter is constructed of premium aluminum material
- Maximum Flow Rate 15 GPH
- Port / Connecting Size M18 X 1.5 Center Thread.
- over 99% efficient at removing
R12T Marine Fuel Filter Water Separator
Fit for
Replace for Many diesel Engine's Outboard motor and Mercury Fuel & Water Seperator
Replace Part number
- Replaces Racor S3240 R12T 120AT;
- Replaces Sierra 18-7987;
- Replaces RK10222;
- Replaces 18-7947, 187947, 17670-ZW1-030GH, 99105-20006, 9-37812, Honda Outboards 17670ZW1030GH, Suzuki Outboard 9910520006, Mallory 937812, 120RRAC01, 120RRAC02, 120R-RAC01, 120R-RAC02.
- 10 Micron Fuel Filter Assembly
- Multi-Layer High-grade
- 10 micron filters are over 90% efficient at removing particles as small as 10 microns,provide strong protection of your fuel system.
- Clear Nylon Collection Bowl
- The drainage bowl is made of reusable clear Nylon can easily see the water leve.
2. Self-venting Drain
- Self-venting Drain designed to quickly and easily remove any trapped water in the filter.
- Fuel Connector 3/8" Out Put
- PTFE Thread Seal Tap
- 3/8 NPT ports offer lower pressure drop rates
How To Use？
- To Drain
- Remove Element From Head
- Remove Bowl From Element
- Lube New Bowl O-ring
- Tighten Bowl Onto Element
- Fill with Clean Fuel
- Lube New Filter Seal Ring
- Tighten Firmly By Hand
EASY INSTALLATION：Plug and play, direct replacement. Always pre-fill with clean fuel on the dirty side of the filter without opening the gas cap. Do not reuse the old filter as this can cause serious damage to the engine. After installing the new filter, fill with fuel and start the engine, wait a few minutes, then check for leaks.
Customer
Reviewed in the United States on February 23, 2025
.great Works
jch
Reviewed in the United States on January 25, 2025
Use it on my Jon boat for a 50 hp outboard. Not suitable for larger engines.
Seth M.
Reviewed in the United States on August 26, 2024
Awesome product was having problems with getting bad gas in my boat and this thing works wonders
E Brown
Reviewed in the United States on March 25, 2024
Too late for me to return it but maybe I can save you the trouble. Weather and other projects delayed my install of this filter/water separator. The female threaded ports are not threaded properly for for a taper pipe thread fitting. Threaded in too deep. Two of the four ports, I could screw the fitting in with my fingers until it hex was bottomed out. I put a healthy layer of teflon tape and it felt like it might have sealed but this thing is leaking all over. Typical Chinese junk.
william pearcy
Reviewed in the United States on October 2, 2024
if you have water in your gas cans and pour it into the fuel tank of the mower or other vehicle, this filter will decant it into the clear bowl where it can be easily removed by turning one valve open to capture it in a bowl or bottle or let it run onto the ground. excellent product and well constructed. easy to mount.
michael
Reviewed in the United States on April 26, 2024
I’ve ran this on my boat for years now it’s cheap and replacement filters are readily available.
Barney
Reviewed in the United States on December 2, 2020
I used to own a wholesale business and I bought direct from Racor, so I knew exactly what I was ordering, although I sold a slightly lower cost version that didn't have the mounting bracket and they only had one in and one out flow ports., Same exact replacement filters. Great filter assembly with a bowl that you can see if there is water in your fuel and easily drain the water off. Great pricing too on replacement filters. I installed one on my JD 5065E tractor and on two boats.Barney
Customer
Reviewed in the United States on October 11, 2019
As a couple other reviews indicated, throw away the plugs and hose barb connectors; they don't have pipe threads and are going to leak no matter how much glue you wrap around them. They are also made of brass which should NOT be installed in an marine environment.I am generally happy with the water separator but really don't like spending money on something I have to replace because the company packaging the parts is cheap. I would be much happier to know I have to purchase the connectors and pay less up front instead of having to pay for garbage that has to be thrown away and still make a trip to the store to get the "right" parts.I also added a couple street elbows to make installation a bit easier. This filter was installed on an inflatable boat so space is a bit of a premium; I needed the fuel lines to come up from below.After the connections were sorted out the installation was simple; just drilled a couple holes, plugged them up with some 5200, and sank the screws in.In case this isn't obvious; one thing that is seriously lacking on most smaller less expensive boats is a water separator and a fuel filter. Most marine fuel docks deliver water with their fuel even if the fuel is pure. Once you get that in your fuel delivery system on the motor (carbs, injectors, etc...) and shut the motor off you will suffer corrosion damage. Removing the water before it gets to the motor at least slows that down if not completely removing it.
Recommended Products
$36.53
$ 16 .99 $16.99