Your cart is empty.
Your cart is empty.At Cardone, quality is the foundation of our corporate culture and the focus of each and every part we sell. We remanufacture all Caliper Brackets to the highest standards to meet or exceed OEM performance. All bolt threads have been thoroughly inspected and tested to ensure trouble-free installation. Feel confident each and every time you apply your brakes, knowing you have Cardone high quality products installed.
Robert Cruder
Reviewed in the United States on July 23, 2020
This part fit the rear brakes of a 2003 Subaru Outback and may fit other years.I had to replace the original because the mounting bolts seized so badly that I needed a 1050 foot-pound impact wrench to remove them. There was very little left of the threads on either the bracket or the bolts and both had to be replaced.The replacement hardened bolts (not found on Amazon but at Auto Zone) were cadmium plated and I would have preferred plating on the bracket as well to avoid repeating the original problem. That lack of plating is why I only gave 3 stars to an otherwise quality product.I could not use anti-seize on the bolts because that changes the required tightening torque and could not use blue loc-tite because it does not fully seal the threads to prevent corrosion. Loc-tite and some other brands make an anaerobic teflon-filled sealant for fluid fittings (Loc-tite lock-and-seal).Again, with proper plating, that would not have been required.
Jeff
Reviewed in the United States on April 19, 2019
ordered two of them, the castings are different. critical measurements seem to be the same but one has less clearance for the rotor. Will be installing soon and will update my review if they work without issue.
oxfordriverrat
Reviewed in the United States on January 4, 2016
A
pt00323i
Reviewed in the United States on February 28, 2015
order these for my wry upgrade, so I order a set one came without 2nd milling process so it is rough by the clips and where the disc rides, not a big deal, but I rather have 2 of the same, so I requested a replacement, fitment is fine, good price also.
G. Bains
Reviewed in the United States on January 20, 2014
Great fit, and looks just like OEM. I decided to reuse the guide pins from my smaller brackets, and just added some new caliper grease.
Recommended Products
