Your cart is empty.
Your cart is empty.Product Description
Technical parameters:
Detection method: Incremental encoder
Signal output: 0 ~ 5V, 0 ~ 10V，0~5KΩ，0~10KΩ，4 ~ 20mA（Please select when ordering）
Range: 500 mm
Wire rope: 0.6mm
Plastic coated wire rope
PULL speed: 600mm/s(MAX）
Linearity: 0.25%FS
Supply voltage: DC 24V
Installation Notes:
* Make sure the wiring in the power off state *Note that the error wiring may damage the sensor
* Do not power lines or power cord with in the same conduit run lines, the signal with a special shielded cable to avoid interference
* Make sure the power supply voltage changes within the rated range
*Do not use when power is turned on after a short period of time (50ms)
*If the product near devices that produce electromagnetic interference (switching regulator, high frequency, the conversion engine, etc.), please do the equipment rack ground terminal to secure the ground at the same time do a good job of shielding the work of the sensor signal transmission
*The sensors are precision instruments ,do not strike, to ensure that equipment and wire rope clean and prolong life;
* To protect the rope from the external injury.
* installation make rope is pulled out, can not let the rope friction and outlet
* If used in a bad environment or for special occasions, please install protection agency orCustomized products contact me
* If you are using non-linear motion of the body, self-designed steering mechanism or to buy the company displacement sensor attachment
*Keep the rope perpendicular out of the outlet as far as possible, maintain a minimum angle (≤ 3degree) in order to ensure the accuracy of measurement and the tightrope of life
Instructions of CWP-S500 series draw wire Encoder
Selection guide of draw wire Encoder
Zann
Reviewed in the United States on September 15, 2024
I've been using this for about a month now, and it's performing well. It's well made and does it's job.
Sebastian O.
Reviewed in the United States on December 29, 2018
Excelent
Recommended Products