Your cart is empty.
Your cart is empty.Use the CircuitSealer pen (conformal coating) to protect traces.
sam
Reviewed in the United States on October 28, 2021
Dried out before 1st use 6 months after purchase
Butterflysky
Reviewed in the United States on January 11, 2018
Works very well and extra handy.
NancyReyes
Reviewed in the United States on September 10, 2017
As expected.
Leslie Howard
Reviewed in the United States on June 6, 2017
Giving it 4 stars because I didn't use it. Thought I was buying the CONDUCTIVE type pen. So just a warning this is NOT a conductive pen.
Grace Davis
Reviewed in the United States on August 25, 2016
I was very hesitant of buying this. I had a printed circuit board on the back of an instrument cluster that had several breaks and corrosion spots. A replacement wasn't available so fixing was a necessity. Cleaned the traces back to a good spot and redraw the traces. You have to wait for it to dry before being able to test for continuity. Very happy customer here
michael crump
Reviewed in the United States on July 28, 2016
It has a sharp pointed plastic tip that you push down on. If you are using it for the conductive ink/paint. it may scratch it off.
Brad
Reviewed in the United States on February 23, 2012
This is a great sealer but I thought sure I ordered the breadboard making pen, I needed them both and it does a great job so if you repair or make your own boards and need to seal them for protection you can't go wrong with this sealer.
Mike Virgil
Reviewed in the United States on February 11, 2010
The purpose:Remake a keyboard short circuited and exploded Printed circuit.Result : I'm typing on it.Problem: After taking all the precautions indicated on the Writer and the sealer I ended up developing my own method and redoing the tracks up to 5 times to get it right.Root Cause: The pin tip are still too think. The trace just short circuits.Solution: Do the trace then use alcohol ,cotton and a pen to clear out the extras.
Recommended Products
