Shopping Cart

Your cart is empty.

Your cart is empty.

Bushing Installation Tool Replacement Hendrickson S21307 for Turner Intraax Wide Bushing Complete Kit

4.4 (2) Write Review
Free shipping on orders over $29.99

$336.00

$ 99 .00 $99.00

In Stock
  • Bushing Type: Wide Beam Bushing
  • Manufacturer Part Number: S21307
  • Bushing Installation Tool for Hendrickson Replace Part # S21307, E9575, TRB5912-T Automann
  • Funtion: For use with Hendrickson Tri-Functional Wide Beam Bushing Kits.This kit will easily remove and install the Hendrickson Intraax Tri-Functional bushing while the suspension remains on the trailer. Made to service most Hendrickson, Hendrickson Turner, Watson Chalin, and Automann bushings
  • Note:Ensure that threads on tool are well lubricated before and during use to avoid damaging threads.The lubricating grease helps you better complete your work


Product Description

Item specifics

  • Condition:New
  • Part Type:Bushing Installation Tool
  • Manufacturer Part Number: S21307
  • Bushing Type:Wide Beam Bushing
  • For use with Hendrickson Tri-Functional Wide Beam Bushing Kits
  • Bushing Installation Tool for Hendrickson Replace Part # S21307, E9575, TRB5912-T Automann
  • This kit will easily remove and install the Hendrickson Intraax Tri-Functional bushing while the suspension remains on the trailer. Made to service most Hendrickson, Hendrickson Turner, Watson Chalin, and Automann bushings

Removal of Bushing：

  • 1.Scribe the bushing orientation on the beam tube and compression tube.
  • 2.The spring pins are not required to line up with the bushing holes during removal.
  • 3.Tighten retaining nuts to remove slack. Thread on hammer adapter in the event the bushing becomes seized. Hook up hydraulics and begin removal operation.
  • 4.After each 2 inch stroke, re-tighten nuts to take up slack. (Most bushing will require 3-4 adjustments)

Installation of Bushing：

  • 1.Lubricate the bushing and insert the bushing into compression cylinder.
  • 2.Place the plunger on top of the bushing, align the mark on the bushing with the mark on the plunger. The 4 corresponding pins to the bushing type you are installing should seat into the bushing.
  • 3.Tighten retaining nuts to remove slack. Thread on hammer adapter in the event the bushing becomes seized. Confirm the plunger is aligned with the scribed mark on the beam tube and the pins are still engaged in the bushing.Hook up hydraulics and begin installation operation.
  • 4.After each 2 inch stroke, retighten nuts to take up slack. (Most bushing will require 3-4 adjustments).Ensure that threads on tool are well lubricated before and during use to avoid damaging threads.

Cross References:

  • For BWP HE9AA-T
  • For Dayton 334-936
  • For Euclid E-9575
  • For Hendrickson S-21307
  • For Meritor R309575
  • For Sirco SH2034
  • For Tiger Tool 15040

Applications:

  • For Automann TS TRB5912
  • For Dayton TS 334-1576
  • For Euclid TS E-10729A
  • For Flagg TS HT245
  • For Gaff TS 13628
  • For Hendrickson TS S-24691

Customer
Reviewed in the United States on February 14, 2025
This is one of my favorite tool easy to used and great resoult
Alex
Reviewed in the United States on August 30, 2024
Great tool