Your cart is empty.
Your cart is empty.Bung Caps 2inch Fine Thread Barrel Caps 6 Pieces and 6 Pieces 3/4" Plastic Bung Caps
harold taylor
Reviewed in the United States on September 27, 2024
These plugs stopped my barrel from leaking
Chadnic
Reviewed in the United States on June 14, 2024
I love these things because I can drill then out to accept different size hoses and the centers still hold up well and don't crack. They are nice and thick.To make sure these last, I treat them with 303 protectant so they don't get call crumbly from sitting in the sun.Another pro-tip is to make sure you use the right tool to put these on on off. If you use channel locks or pliers or hammer it around with a screw driver they will ultimately wear out. Get the right tool and these crank down perfect.
Tamara Wilson
Reviewed in the United States on May 4, 2024
We had 30 gallon barrels we needed caps for. These fit perfectly!!
Florida Guy
Reviewed in the United States on March 7, 2024
Exactly what I needed for my 50 gallon barrels. Thank you
Tad
Reviewed in the United States on December 12, 2024
Did the trick just fine to replace some missing inner caps for my IBC totes. Fitment and quality was good.I only question the compatibility of the o-rings and the oil I store in my totes. But, not a big deal. Would buy again.
Ramona G. Ehnes
Reviewed in the United States on December 22, 2023
Correct threads, but the hole configuration in the bung is not the same as a standard size bung wrench hole for removing the bung. Must be some Chinese type bung hole.
Steve Clark
Reviewed in the United States on November 21, 2023
The bottom, unthreaded piece of the cap is flared and wider than the thread openings in the barrell hole. I had to grind off the flare to allow the cap to seat in the opening and engage the threads. The outer top flange of the cap was also slightly wider that the barrell opening and had to be ground down 1/32" to fit and seal.
ReggieV
Reviewed in the United States on November 16, 2023
The threading on these plugs fit the water barrel needing a replacement. This was a good fit.However, there must be different types of threads for these plugs as they didn’t always fit in some other barrels. I was hoping the manufacturer might explain this unsuspecting buyers to help find the proper plugs.
Recommended Products
