Your cart is empty.
Your cart is empty.Blue Sea Systems' 5056-BSS ST-Blade Water-Resistant Fuse Block provides water-resistant circuit protection for ATO/ATC fuses and circuit breakers in a compact footprint. The single side nesting design allows for wire entry from one side to maximize space. Water-resistant design with standard ring or fork type terminals allows for simple wiring with standard tools. Accepts a wide range of wire sizes. Includes 3 wire plugs to maintain water resistant rating if less than 4 loads are required. Accepts ATO and ATC fast-acting blade fuses. Accepts ATO/ATC-Style Low Profile Circuit Breakers. Nests with other ST-Blade Water-Resistant Fuse Blocks and Water-Resistant 100A Bus Bars to reduce wire. Insulating cover meets ABYC/USCG insulation requirements. Tin-plated copper busses and fuse clips. Includes four write-on circuit labels. Small format standard and custom labels available.
Duane Schmaltz
Reviewed in the United States on July 9, 2024
Mounted to add power supply to jetski electronics. Perfect size and waterproof too!
3G
Reviewed in the United States on February 19, 2024
used to mount inside T-Top electronics box for accessories
DC
Reviewed in the United States on December 6, 2024
This is a well designed fuse block with quality materials that fit my needs for compact installation on my off-road vehicle. The Blue Sea Systems electrical components that I have used, withstand the rigors of temperature/ moisture/ vibration that I expose them to in my off-road vehicles over the years.
Andy
Reviewed in the United States on January 17, 2024
Used this in a vehicle and couldn’t be happier. Very clean way to install some extra 12v stuff. The screws that hold the front on are retained in the front face when you unscrew them to get inside- so no chance of dropping/losing the screws. Very well designed! I will use only Blue Sea from now on.
R.G.S!
Reviewed in the United States on August 17, 2023
Works good.
Richard M.
Reviewed in the United States on June 24, 2023
Used mine for multiple power source for the rear of my tractor. Just know that it is only a positive buss bar and the ground must be used from another source for the light or switch from the battery or frame. This is what I wanted because I would have less wiring going to this box (only positives) and use a grounded OE factory bolt for a ground. No problems when washing the tractor, but I would not applied a direct high pressure spray. I would trust it in a heavy rain though. Would buy again if I need one!
Old_Greggg
Reviewed in the United States on November 4, 2023
Bought this to build a 12V electrical system for my Boston Whaler.Easy to install, nicely made and compact. Waterproof seals look to be good quality.
Mischele
Reviewed in the United States on October 8, 2022
I installed this at the batteries to clean up the mess of inline fuses for the bilge pumps and the bridge 24 hour buss...
Recommended Products
