Your cart is empty.
Your cart is empty.Torin AT32100B engine and workshop crane accessory is a 3-position steel engine leveler with an adjustable handle. It features a load capacity of 3/4 tons (1500 pounds) making it is an ideal choice for garage, workshop and agricultural work. Featuring (4) 14" Long chains, each equipped with an L-shaped bracket assembly. It is fully adjustable, with three position chain mounting holes to adapt to different engine configurations. Simply connect the chain to the engine, and use the crank handle to quickly and easily adjust through the threaded shaft to easily balance the load. This heavy engine leveler is easy to change the center of gravity, saving time and labor. It also includes a one-year limited manufacturer warranty.
Johnny B
Reviewed in the United States on February 5, 2025
Excellent product and price
Jorge A Ruiz
Reviewed in the United States on May 14, 2024
It does work flawlessly and makes removing and installing in engines a breeze! The quality is definitely there and very easy to use
71 nova
Reviewed in Canada on March 16, 2024
It worked well could be a bit more robust the crank handle is pretty flimsy, however it worked
tmhgator77
Reviewed in the United States on November 11, 2024
Worked perfect to lift my C5 Corvette Engine. It was supported a little uneven due to the alternator bolt being higher than the hole in the block on the other side of the engine which were the two points I supported the engine from. Still worked to support/lift the entire engine attached to my 1,320 Lb Electic Hoist. I highly recommend this if you are lifting an engine or something heavy that it would work for from above.
cory
Reviewed in the United States on September 27, 2023
Could be better built but works good for how cheap it is.
EFD
Reviewed in the United States on September 22, 2023
They are a good price for the capabilities. I use to to pick up my 120 lb dog in a harness so I can clip her nails. It's easy to set up and use. It works great for what i use it for
t
Reviewed in the United States on December 5, 2023
I might change the chains out for something a little longer to fit engines I'm working on. I need to hook up to engine anchor points which are low and it makes it a little harder to use. Another 6-12" on the chains would be better for me.
Customer
Reviewed in the United States on December 31, 2023
Make sure to shorten the links to two at the most so you can get the lifting height to pull out the engine. I just put the bolt through the link, so it was as short as possible since Ford did not give much clearance to pull up the engine upward to disconnect from the torque converter.
Dee K
Reviewed in Canada on November 30, 2022
the handle to turn is too short and will hurt your fingers.
Juan C.
Reviewed in the United States on September 6, 2021
No aguanto lo que quería levantar
Recommended Products
