Your cart is empty.
Your cart is empty.Product Description
fbp
Reviewed in the United States on March 10, 2024
Bulging eyes will not allow the fish to release from its mold even after thoroughly curing. The mold was greased but kept breaking every time. These molds aren’t worth buying so save yourself the hassle. I finally cut the eyes off and reshaped the upper lip so they would release, but have to go back and repair the eyes and mouth.
Ann john
Reviewed in the United States on August 6, 2023
It's does work well, the fins may not be thick enough, had some minor cracking, but that could have been my mix. I highly recommend this one. I tried metal form of a fish, did not come out of mold even with oils, this one just popped out with ease.
Customer
Reviewed in the United States on June 5, 2023
The molds were very hard and stiff, not like the softer plastic molds. Most of my fish had cracked no matter I gently I removed them from the plastic.
mike
Reviewed in Canada on October 3, 2023
Not sure where they get 2 mm from, measures 1mm on flat edges. Feels barely more than the thickness of product packaging. Very stiff. Tiny lips that make removal imposiible without breakage. Like the fish shapes though. I used a heat gun to re shape edges so i can get positive results. Their vacume forming machine is creating a ridge at the edge of the fish. Make sure you use oil and give your models 48 hours to cure minimum. Once ready to de mold i found sitting them in the sun for 30 min ,plastic side up, helps expand the plastic.
Recommended Products