Your cart is empty.
Your cart is empty.Product Description
- Designed to meet or exceed original quality and performance.
- This tool is usually used with the engine alignment tool.
- Pls Confirm the Item if It Matches Your boat Before You Purchase.
- It fits for Alpha 1 Generation 2, Bravo, Blackhawk U-joint bellows.
Direct Replacement
- Alternatives for Sierra # 18-9870.
- Replacement for Mercury / Mercruiser 91-818162.
- 1x Bellow Retainer Ring Install tool
Function
The drive shaft bellows sleeve installation tool is used to install the aluminum ring into the Alpha 1 Generation 2, Bravo, Blackhawk U-joint bellows.
Easy to operate！
STEP 1
Apply Bellows Adhesive to Gimbal Housing.
STEP 2
Put the Aluminum Rings into Gimbal Housing.
STEP 3
Then put the Bellow Retainer Ring Install tool in and fix it slightly.
STEP 4
Use the engine alignment tool hammer in it!
Mechanicman
Reviewed in Canada on May 13, 2024
Does what it should. Durable. Perfect fit
Bill Hall
Reviewed in the United States on July 14, 2023
product was as described
Customer Claudine
Reviewed in Canada on June 28, 2023
We’ll pack deliver on time,, made lexactly like I need,, only thing last time I got one online ( was a tad smaller then I needed plus it crack in haft !!!But new company so there will b a update in about a week for this tool
Customer
Reviewed in the United States on June 14, 2022
Did exactly as it was supposed to do well worth it for sure
Customer
Reviewed in the United States on January 6, 2021
Solid construction and would recommend to anyone replacing the bellows on an alpha 1 gen 2. I tried to install the sleeve without it but no luck, with this tool it took one try.
Carter
Reviewed in the United States on December 3, 2020
Installer was a thick piece of machined plastic. The dense plastic can take a good beating and fit right over my bearing alignment tool.
John Deere
Reviewed in the United States on December 27, 2020
Perfect fit. Saves lots of time and frustration.
Robert B.
Reviewed in the United States on December 23, 2020
Works perfect for driving the gimbal bellows seal!
David B.
Reviewed in the United States on December 20, 2020
Great product. Easy to use and makes the job easy.
Berton Owens III
Reviewed in the United States on December 15, 2020
Driver worked just like it should, ring fit just right on the driver. My gimbal was out of the boat when the bellows was installed, but shouldn’t be much different doing a repair on the boat
Recommended Products