Your cart is empty.
Your cart is empty.
- DPST toggle switch with screw terminals.
- 125 VAC, 20 amp.
- 1/2" mounting hole.
BoomerSooner
Reviewed in the United States on March 8, 2025
Rugged, heavy duty switch.
A. Dawson
Reviewed in the United States on February 8, 2025
Bought this to replace another toggle which failed in one day. Now, after about 10 uses, this one is failing too...
Beck
Reviewed in the United States on February 12, 2025
On a 5A (continuous load) at 120VAC circuit, these switches lasted me about 2-months, and I have tried several of these - SP and DP. I have tried a couple on about 10A/125VAC and they lasted about 2-days. You get what you pay for. I would not buy again.
K8888
Reviewed in Canada on January 24, 2025
I used this on an old machine that was missing it's switch, it worked, but it seems that it's durability is limited. The machine needed to be switched on and off frequently during use, and eventually I'd have to flip the switch multiple times to get it to turn on or off. Not ideal but got the job done while I needed it. The equipment power use was within the spec of the switch, but maybe would've lasted longer if i had picked a higher amp rating.
Kiel E. Murray
Reviewed in the United States on June 30, 2024
Bought a Vevor air pump to aerate a pond. The switch supplied burned up probably not rated correctly. Put this switch in and not having an issue.
DAVID PAULEY
Reviewed in the United States on June 18, 2024
Had it hooked up in minutes. Value for the money spot on. Quality was good. No stiffness at all in the stitch
Robert T. Petrus
Reviewed in the United States on December 5, 2024
I used these switches to control track power segments on my HO Train Layout. The On/Off metal plate is helpful when it is seen on my control panel. My power is low voltage, around 15 VAC.
Robert Abeele
Reviewed in Canada on December 23, 2024
Used to replace switch in my Marita router
Wink
Reviewed in the United States on July 8, 2023
I'm rewiring an old table saw. Circa 1940s. This worked but be advised if using 12ga wire the connectors are small. I put ring crimp on connectors on and that got the job done. That is probably not to code but it's my table saw so that doesn't matter. Please don't tell my insurance company. ;-)
Setjdgh
Reviewed in the United States on December 31, 2023
seems well built, will update review if/when switch fails.
Recommended Products
