Your cart is empty.
Your cart is empty.For mechanical pressure gauges (except fuel, nitrous, or brake pressure gauges). Includes 6 ft. of 1/8 copper line, 1/8 NPT Male to 1/8 compression fitting, 1/8 NPT Female to 1/8 compression fitting, grommet, and 1/8 NPT to 1/4 NPT bushing.
Rick
Reviewed in the United States on January 30, 2025
Worked great for my oil gauge
James Jenkins
Reviewed in the United States on June 30, 2024
Works great to replace plastic hose
Eddie
Reviewed in the United States on June 16, 2024
What I needed
Jeff johnson
Reviewed in the United States on March 28, 2024
Made well
everton
Reviewed in the United States on March 27, 2024
Good description, solid brass construction, fits well. Although there are cheaper brands out there, you can go wrong with anything Autometer ..
Eric Leendertsen
Reviewed in the United States on October 21, 2024
I chose this over the clear plastic vinyl tubing for a couple reasons it's brass and will not melt like the plastic also less likely to rupture under year's of use
shawn
Reviewed in the United States on July 15, 2023
Good 👍
Terry Barkley
Reviewed in Canada on February 23, 2023
This came with all the fittings needed to install. Very good product.
Martin Lenneville
Reviewed in Canada on October 9, 2023
Bonne etat
Rene
Reviewed in Canada on January 8, 2023
used this on a Auto Meter oil pressure gauge for a tractor.I passed the pipe through a 1 foot rubber hose.flared each end then made 3 ring coils at each end of the pipe to cut even more on the vibration and tie wrapped.All went well works fine.
kenneth clarkson
Reviewed in Canada on March 14, 2020
Item arrived on time and as described. We used this instead of the cheap plastic tubing that the gauges come with. This was installed on my sons Ranger that we supercharged
Old School Techie
Reviewed in Canada on November 25, 2019
I bought this to use on an oil pressure gauge on a small diesel tractor. The problem I had was that the engine vibrates, especially at idle, putting stress on the tubing. Even though I left a coil of copper tubing between the engine and the frame, to try to absorb some of the vibration, the tubing would break off at the fitting on the engine, spraying oil everywhere. I ended up buying fuel injector hose at a auto supply store and just clamping it on, at the engine end, using a barb fitting. At the gauge, because of lack of space, I just clamped it on the threads. This method has given me no problems. If there was no or minimal vibration I am sure it would have worked well.
Chris Miller
Reviewed in the United States on October 20, 2015
Used this line to replace the plastic tube that came with my oil pressure gauge so I can have my vehicle on the track. I have noticed a sizable buzzing now coming from my gauge after using this. after some research I found that this is somewhat common since it provides a direct acoustical path that the plastic tubing did not provide. Make sure to put service loops in in both the engine compartment and the cab if your routing the gauge through the fire wall. This was a low cost option that was better than the poly tube that would meet track regulations. I am working on ordering parts and running stainless steel braided lines to remove this buzzing. Granted also being on full polyurethane bushings and aggressive built motor does not help either.
Recommended Products
$28.99
$ 13 .99 $13.99