Bought these after realizing my normal P12 fans didn't fit my case. Since they can be linked together I could also return my fanhub. I have been using these for about three months and have zero complaints.

These fans seems to move a good amount of air through my pc and are fairly quiet. Especially after tuning the fan curve. Solid choose for affordable fans that are not too noisy

Hardly any noise, fits perfectly between my gpu and case. Daisy chaining makes great use of limited fan headers on my itx motherboard.

This three pack was an amazing upgrade to the thermal status of my system. Installed seamlessly with either the long screws into the case or short screws into the fans. System integrated them into the fan control sub-system to provide RPMs on demand. Very minimal increase in noise considering went from three to six fans with this addition.

These things are a godsend if you have a massive heat sink on your motherboard and can’t fit traditional 25mm thick fans. So far so good, they run cool, make zero noise and are sleek and look great in my blacked out build. Also priced adequately and great value for the money.

The small size is great for itx builds, and it wasn't loud. Was really impressed with this as it was part of a solution to help a problem with a build.My daughter has a small itx machine (super small case) where I upgraded her video card from a low power NVidia 50 series to a 70series and there was some airflow issues. I couldn't move the top fan down to the exhaust because of the clearance of a standard fan wouldn't fit over the heatsink on the machine. This one came in clutch though and the extra PWM sharing cable made doing wiring super easy, mostly with the limited fan headers on the ITX board.The fan worked fine for me. They aren't Noctua's, but it did work without issues for me.

Oh man. I was planning on cutting screws to length but Arctic included 12 radiator screws in addition to 12 regular fan screws.Absolutely stellar. Amazing value. I'm just using them to help pull extra air through the radiator so I'm sure they'll be fine, not too worried about airflow. I mainly did this because I didn't want to lower the radiator down by 25mm with a regular fan, I didn't want it to be that low in the case. This was basically perfect.In hindsight, however, on the Hyte Y70 at least, I think full size fans would have hid pretty good up there. You would probably just see the bottom side of the fan, barely. There's more room up there than I thought.

Artic is solid quality, very quiet, flows a lot of air. NO RGB** wanted so I ordered these. Enough crap in my PC has the psychadelic light show.. kb, AIO cooler. Just a simple black fan

I got two of these ultra slim fans because my case don't have a lot of room. There quiet and push quite a bit of air. I did although had to modify one of the fans mounting holes because it didn't clear my ram locking tab. But other then that, there VERY reasonably priced. An not to mention, i love the sleek black look. Im not an RGB fella so the black look is VERY clean.

Dentro de los ventiladores de la línea económica, este modelo y esta marca son de las mejores opciones, si es que no la mejor. Personalmente, he quedado muy satisfecho con el desempeño de este modelo.

I used 2 of these for a deshroud mod of a msi 6700xt mech 2 that was getting way to hot with tj temps hitting 110 emedietly under any load, I also repasted the core and put new thermal pads on everywhere, I also needed a set of gpu pwm fan header to 4pin fan header adapter, now I'm not directly put hate on the 6700xt this heat issue was entirely my fault I had put this already hot running card into the wierd mounting position of an h1 v1 Rev1.0(I replaced the fire starter pcie risser and destroyed the old one so no worrys) and that case had the gpu verticle long ways with the gpu io down so the whole heat threw the channel design of most high end gpus with "heat to the back to the io" simply is turned on its head in this case BUT these slim fans fit perfectly and altho i do still get high junction temps these fans can spin at full speed and there whisper quiet unlike the ones from msi which were the only things I could hear in the entire home office...unexceptable...but these bairly fit into the space between the mesh filter and the deshrouded heatsink of my gpu and they don't make any noise at all and they do infact keep the regular temps down a bit so that's a double win in my book, I can sustain full load on the gpu without throttling so that's a successfull deshroud mod in my opinion and for the cost..ya I like this build now with its 128gb of ddr4 4000mhz and 5800x3d it has evolved to be a very nice linux dev and gaming system for me...

En muchas ocasiones las personas ahorran mucho tiempo para comprar su PC (yo siempre recomiendo a mis clientes gastar más en GPU y CPU) por lo que muchas veces terminan comprando gabinetes pequeños sin salida de aire... pero créeme que estos ventiladores son UNA JOYA para solucionar eso.TAMAÑO:Para empezar es un pack de 3 y al ser SLIM (marco más delgado que el normal) va a entrar en casi cualquier gabinete... yo los instalé en mi 2da PC destinada al stream, es un gabinetes Yeyian Haizen 2500, el cual ya trae 3 ventiladores pre instalados (nada malos por cierto) te darás cuenta que hice un mix, puse un artic atrás, uno arriba y al frente los cambié por un yeyian para ese ponerlo arriba. Entonces por espacio no te preocupas.CONECTIVIDAD: NO NECESITAS CONTROLADOR... en el nombre si pones atención dice "PST" (PWM Sharing Technology) significa que todos se pueden conectar en cadena (Daisy chain) a un solo puerto de tu motherboard. Cada ventilador tiene un cable con una conexión en "Y", esto es para que la primera cabeza vaya a algún puerto "CHA_FAN" de tu motherboard y a la otra le conectas otro ventilador y así sucesivamente como te lo pongo en la imagen. La verdad que esto esto se los recomiendo a mis clientes con motherboards con pocos puertos "CHA_FAN" porque solo te toma un puerto para conectar 3 ventiladores.Consejo: es mejor conectar todo directo a la motherboard para controlar las rpm o su curva de ventilación desde la BIOS y así optimizas recursos para no abrir más programas.CONTROL:Pero si no le sabes a la BIOS puedes visitar mi canal de youtube "El Macmado" o cualquier red social con mi nombre y preguntarme por mensaje.O dependiendo de tu motherboard tendrás un programa para controlarlos, la mía que es ASUS usa el "Ai Suite 3" solo entras, buscas la opción de "Fan Xpert2+" y le das en "Ajuste de ventiladores" para que te los reconozca y te haga una prueba (como la de pantalla) cuando termine ya puedes poner rpm's fijas o hacer tus curvas de ventilaciones personalizadas.RUIDO:El ruido que haces es increíblemente bajo, hace más ruido el ventilador del procesador (porque gira a más de 3000rpm y los artic máximo a 2050) por lo que puedes hacer la prueba para que te des una idea del ruido. Además tienes un muy buen flujo de aire y presión estática por lo que avientan bastante aire de frente y mueven bastante aire.TEMPERATURAS:Antes tenía mi gabinete sin panel y mi CPU (i5 11400F) iba a 60 grados y mi GPU (EVGA 1660 ti) a 45 sin hacer nada.Con estos ventiladores y panel cerrado voy a 48 en el CPU y 32 en la GPU.Te dejo una imagen para mostrarte todos los programas, la carga y las temps de mi PC de streams.CPU a máximo 65 grados y GPU a 43 máximo, con toda la carga de mis programas.Los programas que uso son:- OBS Studio (con previsualización normal para twitch y vertical para TikTok).- Streamerbot- Discord- Lumiastream- GoXLR Utility- Spotify o TIDAL- Songify (para que añadan canciones mis espectadores- Snap Camera- MSI afterburner- entre otrasEntonces resumiendo... ¿Valen la pena?SIN DUDA ALGUNA, los he puesto en 4 pcs y en todas me redujeron bastante las temperaturas.Si tienes duda mándame mensaje a cualquiera de mis redes: Elmacmado.Saludos

These fans saved my new computer build! I underestimated the size of my new graphics card when I was installing it in my case, I did not have any room for the normal size fans and so I bought these.They were very easy to install and because there is a daisy chain connector I can make my cable management very clean. They are very quiet in-comparison to the Corsair fans that I used previously in a different build. I would definitely buy these again if I were trying to attempt an ITX Build sometime in the future.