Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on February 27, 2025
Poor quality. Had a hard time getting transmission cooler line fittings to seal on installation. Lasted less then 6 months before it started leaking coolant from where the tank meets the core.
Scott Smith
Reviewed in the United States on January 15, 2025
Fast shipping. No damage. Came with the oil and transmission cooler adapters. It's running great and installed perfectly. Great value and I'm satisfied.
Tim
Reviewed in the United States on January 10, 2025
Fit perfectly and has 18 fins per inch which is good.
Crystal
Reviewed in the United States on September 9, 2024
The media could not be loaded.
Timothy J
Reviewed in the United States on June 29, 2024
The radiator fit my Suburban perfectly, It seems more sturdy than the one I took out, but I am not absolutely sure, since I put it in the car as fast as I could. If I hadn't had to rely on YouTube videos, I would probably gotten it installed in an hour or so, but I did and it took most of a day to finish the removal, addition, and replacement of the stuff. There was a lot of stuff to remove, so if you get one, be careful not to lose any parts, like I did with one of the clamps
Mario
Reviewed in the United States on February 17, 2024
When I opened the box I found small dents on the fins I just crossed my fingers and hope that it didn’t have hole on it. For the most part it did not leak it’s been about a week driving it without issues. Perfect size for my 5.3 trans cooler lines on radiator like I asked for. So far so good I will update in a month.cause I drive it a lot and it’s flipping cold so it’s going to work a little harder but great radiator so far. Thank youUpdate: no leaks and is working great I recommend this radiator..
Shawnathon
Reviewed in the United States on November 4, 2024
Bought this for my 07-13 Silverado 5.3L. It was an exact replacement and actually has a drain plug whereas the factory does not. Plug is on the lower drivers side! It came with new transmission line fittings and clips also. I did have to take the mounting rubber bushings off the old radiator but that’s no problem at all. Push them out of the top mounts with a flat edge screwdriver then the bottom mounts has a tab you push and slide off old bushings. Slip them back on the new one. Entire project took me maybe 2 hours tops including refilling and burping system. I’m on the second day of install and so far so good. Will retouch back after awhile with update. Happy so far!Update: almost 2 months later and still doing great! No leaks no probs
Customer
Reviewed in the United States on November 11, 2024
Fit perfectly works great
Recommended Products