Your cart is empty.
Your cart is empty.Product Description
Heather K.
Reviewed in the United States on September 24, 2024
I installed these two weeks ago. I wanted to wait for the heat wave to go through to see how they held up. My worry was one of the insets would get hot and fall off, but that did not happen. They are still looking good.Basically, these are chrome cups with a punisher sticker. You take out your current license plate screw or bolt, slide the chrome cup on it, and screw it back in. Then, you put the sticker over it to hide the screw or bolt. If your bolt is too wide, this comes with bolts and nuts to use as a replacement. I didn't need them. There is a set of four because most people only put two on each end. If you are using all four holes for your license plates, you will need two sets.
Kyle Pope
Reviewed in the United States on July 26, 2024
I purchased these on the Amazon recommendation that they fit my 2019 Kia Sorento. The diameter is correct but the length is too long.
Ramiro Castro
Reviewed in the United States on July 10, 2024
Had my license plates stolen and decided to look into something a little more secured. Most vehicles come with the same screw format, which obviously uses a simple flathead or can be easily removed with the coin, I love that the screw on this is rounded and also uses its own unique key to unscrew. Also, like the fact that they included a small bit for those who like to use drills
R. A.
Reviewed in the United States on June 16, 2024
Firstly, I don't know why license plate screws don't come in one standard size. These fit only my rear plate mount - my front mount uses much smaller screws so I could only use them on one plate. I don't see these coming in any other size, which is unfortunate.Also, most rear plates that I have seen only use two screws but 4 come in this set, so I have twice as many as I need. My front plate mounts with 4 but only 2 for the rear.These come with a lot of little extras that make mounting the plate a little nicer and more esthetic as well. I didn't see any need for the adhesive pads but I suppose they would come in handy in certain applications.Overall these are a good idea but make sure they are appropriately sized for your car.
sbr11
Reviewed in the United States on December 22, 2024
Great quality and nice way to secure a license plate.
qwolf0
Reviewed in the United States on October 13, 2024
Perfect for factory threads on 24 Sienna license plate holes.
Donny
Reviewed in the United States on December 22, 2023
Works good don't over tighten or that's it
Alfonso
Reviewed in Mexico on August 19, 2022
El producto me pareció muy práctico para evitar el robo de placas o que los policías intenten quitarte las placas, ya que la llave con la que se atornillan no es muy común. Lo recomiendo ampliamente.
guillory82
Reviewed in the United States on October 9, 2020
These are Awesome. One kit did my front and back and the look great. I literally didn't need to get any if my own tools to do install, and comes with plenty of hardware to choose from to match your vehicles mount. Only drawback on my install was on the front plate. Couldn't get a flush mount on the front due the type of plate frame I have and the limitation of the black mount not allowing the plate frame to raise any higher. You have to get down really close to notice it's not flush in the front and I can live with it. As you can see the rear plate mounted nice and flush. The Punisher buttons just stick once the plate is secure. It was a little difficult to get backing off so careful not to damage the sticky edge as you want it to tuck into the hardware nice and flush. I go thru an automated car wash that is spray only type and so far I have not seen any indication of the Punisher buttons coming loose from higher pressure water spray. Definitely recommend product!
Recommended Products