Your cart is empty.
Your cart is empty.4.3 out of 5 stars
- #45,704 in Musical Instruments (See Top 100 in Musical Instruments)
- #520 in Electric Guitar Electronics
Descriptions:
- This potentiometer is perfect for electric guitar/bass building,for pickguard/control plate mounting
- Acts as a normal volume or tone control,and pulls up to activate its on / on double-pole double throw mini switch
- Controls pickup phasing,series / parallel switching and coil-taps
- B Type,full resistance is 500K ohm,push-push pot & DPDT switch,with solder terminals
- Short (19mm) split knurled diameter shaft 1/4" (6mm),thread shaft diameter 3/8" (9.4mm),durable
Specifications:
Mounting Style:Panel
Bias:Linear
Number of laps:1
Resistance:500 kOhms
Item Type:Carbon
Shaft Type:Knurled / Serrated
Termination Style:Solder Lug
Power Frequency:200mW
Tolerance:20%
Shaft Diameter:6mm
Shaft Length:19mm
Package Included:
3 x B500K Guitar Potentiometers
RoninOne
Reviewed in the United States on February 6, 2025
Good value priced item. Works well.
Kenneth
Reviewed in the United Kingdom on August 13, 2024
2 of these didn't pull after being soldered. Best I can guess is that the components inside are made of plastic anc cannot cope with the heat of soldering.While on that point, the holes in the terminals are miniscule and you are unable to fit wire through, it is very difficult to get a good connection with the solder even after sanding the surface to get grip.Do yourself a favour and buy mojo, alpha or cts just avoid these!
Dani
Reviewed in Italy on June 16, 2024
Ok
Recommended Products
