Your cart is empty.
Your cart is empty.Allstar 36 inch Long x 2 inch 12-Gauge Steel Wide Axle Housing Truss Support for Ford 9 inch Model fits the Ford and measures 9 inches on it's differential models. The measurements are 36 inches long x 2 inches wide and is made from high-quality 12-gauge (. 108 inches) steel. The support adds strength to the rear axle housing and reduces unwanted flex during extreme torque. It is backed by a 90-day limited factory and sold individually.
Kyle
Reviewed in the United States on October 6, 2024
The fitment was aweful. Couldn’t even trim it to save it. Had to throw it out and make a custom one
constantinos ratatsidis
Reviewed in Canada on January 10, 2022
The brace is ok but I'm not sure I ordered the correct brace or not. Had to modify to fit properly on my 69 Bronco 9"
glen forbes
Reviewed in Canada on March 8, 2021
Fit was Spot on...and Goid Thickness...thanks
BIGStroker350
Reviewed in the United States on October 23, 2018
Used to strengthen a ford 9 inch off a 80's f150 for a derby car. Welded right on good fit. Even took a hard shot from a bumper with no problems. I added some angle iron to support my mounts
benjamin
Reviewed in the United States on July 17, 2015
nice little BACKBONE TRUSS. The steel it's made of is a little thin but good cuts and bends I have yet to install but will post a follow up review. The main thing is this is a back bone truss it welds to the back of the axle where the differential cover would be. It arrived within a week can't wait to put it on
Recommended Products
