Your cart is empty.
Your cart is empty.Allstar Red Plastic Fitting Cap for -16AN and 1-5/16-12 Thread (Pack of 10) fits sizes -16an and 1-5/16-12 threads and is made from high-quality aluminum. The cap plug kit is a must for keeping debris out of lines and hoses. It is ideal for keeping internal components of dry sump pumps, fuel pumps, pressure regulators, etc. clean during storage. The cap fits 37 degree flared fittings and straight threaded ports. It is sold one set of 10 pieces. It is backed by a 90-day limited factory .
Daniel
Reviewed in the United States on February 10, 2025
Perfect for capping off fuel lines or other fluid lines when disconnecting lines.
Bob Thompson
Reviewed in the United States on January 12, 2025
These caps do a great job of covering ð openings of AN-6 lines to keep debris out while getting ð lines in place. No, they aren't for test pressurizing ð lines, just keeping foreign material out. Note that these are for male fittings. I consider these a must-have when making AN-6 lines.
kskalla
Reviewed in the United States on May 22, 2023
Great value
Ryan B.
Reviewed in the United States on March 5, 2020
These are awesome. Used them on my Acura integra valve cover while getting the motor set up tuned in. Tight fit and didn’t leak although I wouldn’t trust them on the oil pan lol.
CorporationsAreASPD
Reviewed in the United States on October 1, 2020
The cap on my 3oz tube of dielectric grease cracked. I can't seem to find the original caps anywhere so I got these and they fit perfectly. Very happy, plus now I have extra caps for tubes of RTV and whatnot.
Warren E Benson
Reviewed in Canada on November 7, 2015
Just what the doctor ordered, thanks.
tim
Reviewed in the United States on September 19, 2013
I ordered a ten pack and got just 5 pack after they told me my order shipped complete, now its going to take a week to get the other 5, horrible customer service, im done with amazon for good
DOHC
Reviewed in the United States on December 2, 2013
I used these to protect threads on my reloading dies when in storage. Just helps to keep finger salts off of the threads as well as making sure threads aren't marred or dinged. They have a nice snug fit on my LEE die sets, and I haven't seen anything out on the market like them.I would recommend for anyone who has a large number of dies, who doesn't store them in turrets or presses. If you need male inserts for your turret positions or presses, take a look at this product:
Recommended Products
