Your cart is empty.
Your cart is empty. This is a 100% brand new Pair of Replacement LED Tail Lights in Red Clear Lens
Compatible With:
2017-2018 Ford F-250 Super Duty
2017-2018 Ford F-350 Super Duty
2017-2019 Ford F-450 Super Duty
ATTN: Compatible w/ Blind Spot Monitor Models Only
ATTN: Compatible w/ Factory LED Tail Light Models Only
rroustand1
Reviewed in the United States on March 18, 2025
Perfect fit and very bright
m.b.romo
Reviewed in the United States on April 5, 2025
These lights look really nice
Traycee
Reviewed in the United States on September 4, 2024
Lights fit perfect and look better than factory ones.
Fedupwithkids
Reviewed in the United States on September 12, 2024
These work just fine but the fitment is terrible. If you get the bed side to fit where it should, the mounting bolts behind the tailgate don’t line up. You get the mounting holes to line up so you can screw it into place and it pops out of the pin fitting. I wouldn’t recommend.
chris
Reviewed in the United States on February 6, 2024
Came a day early. Easy to attach censure and wires.
Glenn White
Reviewed in the United States on July 24, 2023
If your truck has the FACTORY LEDs and BLIS system……. These taillights will replace the factory lights directly. You just have to swap the BLIS sensor into the new housing.
Marc Peters
Reviewed in the United States on April 13, 2023
They put don’t say you need to rewire your truck. It’s not a plug in and play. Need to rewire your back tail lights and make sure you do it rite. Lol or you will have issue later They need to post that on Amazon. Not just say it will fit a 2018 to 2020 truck. Not even close. I called the company and they just said ya it’s not a plug and play tail light. Need to rewire truck. Sorry. Just return them. OOOOKkAAA. Lol Waist of time That’s all.
Martin Bouliane
Reviewed in the United States on December 7, 2020
These tail lights look good and fit well. However, there is one serious issue that can be resolved if you are handy. The snap pins shown in my picture are too small and do not actually snap in place. Obviously a big problem because you can’t secure the light properly.Instead of returning the product, I decided to use the pins from my factory tail lights and install them on these new lights. This requires you to drill the hole deeper because the pins are not the same thread design. You want to drill undersized such that the thread can bite. Also be careful to clean the chips as you drill because if they fall inside the housing they will be visible. I have used hot melt glue to install the factory pins in place and it seems to be holding up so far. My truck is a 2017 f250 platinum. Not sure if other years have different pins but this light was supposed to fit my truck per description. I can’t figure out how they screw up this pin design so bad but these lights are a fraction of the price compare to Ford’s so I am still happy.
Recommended Products
$58.12
$ 29 .99 $29.99