Your cart is empty.
Your cart is empty.Product Description
90 Degree Clamps for Woodworking with box
john williams
Reviewed in the United States on January 3, 2025
Good service
Customer
Reviewed in the United States on January 22, 2025
Comes in an easy-to-use storage box. no instructions but easy to figure out
Ricardo Garcia
Reviewed in Mexico on January 18, 2025
Muy buenas para ajustar tablas a 90 grados. Sólo no dejen que caigan al piso porque son muy ruidosas.
Tony Ferrante
Reviewed in the United States on August 28, 2024
I paid $25 bucks and that’s a super value; it would have cost me $16 just to buy screw clamps for my 123 blocks so essentially I got the four alum angles for $9 more. That’s a great value! Good quality, good finish, well packaged, no complaints. The alum angles are not a perfect 90 degrees but they are darn close, I estimate some corners about 1/4 degree off which is bad if you’re a machinist but fine for woodworking. Pictures show the worst angle slopes .002” from outer edge to center and you can see a tiny bit of light if held up to a precision square but almost perfect. I’d buy these again in a second!
Geovanni
Reviewed in Mexico on August 25, 2024
Facilita el armado de cajones y muchos otras cosas.
Adam
Reviewed in the United States on July 24, 2024
Decided to build new cabinets for the kitchen. Figured I'd give these a whirl for the price. Out of the box, I checked accuracy on all of them, they all read a true 90°. So far, so good. They are great quality and look great as well. Super easy to use and perform like they should. Great for clamping inside and outside corners.
Customer
Reviewed in the United States on July 1, 2024
As a square clamp it's fine. But. They went out of their way to put measurement markings on these, and those are wrong. Had they not gone out of their way to make this mistake i'd give it five stars.In the first image i put 3 of these against each other, 2 as squares and the bottom as a straight edge. All of the sides touched with no wiggle. So the square is good.In the second image i moved the straight edge up top. On the Left the "10" mark on top lines up exactly with the 10 on the bottom Left. That should put the top's 20 mark exactly in the middle of the two bottom ones (yes, they are still touching). And then, the top's 30 mark should exactly line up with the bottom Right's 10. It does not. It's off by almost a full mm. Not good.Thankfully, i did not buy these for their measure markings... otherwise it would get 0.
Phillip Brent
Reviewed in the United States on February 15, 2024
Pros: Very well machined clamps and true. Markings are engraved and easy to read. L bolts are true. Knobs have brass threaded inserts.Cons: A hair too much play in the fasteners. Typical Chinesium. Nothing I can't live with. Probably not like scotch in a keg getting better with time. The fasteners are easily replaceable if things get too sloppy like my ex. These are metric which shouldn't matter if you're an imperial fan and only using them for glue ups.I will buy more when the $$ is right.
Arek
Reviewed in the United States on December 19, 2024
It works on little projects but doesn’t really hold it well in place how it’s suppose to.
Pencilbox
Reviewed in the United States on December 18, 2024
Great for squaring stuff
Recommended Products