Your cart is empty.
Your cart is empty.Product Description
Strong Adhesive Design
The adhesive foam sheets are backed with a strong adhesive for a strong bond and can be used as spacers and insulating strips.
Waterproof and Non-absorbent
Waterproof and non-absorbent neoprene foam padding that lasts longer than ordinary sponge foam.
Easy to cut to DIY
Easy-to-cut material allows you to create freely with your imagination.
Vibration Dampening
The foam rubber sheet absorbs vibrations, reduces noise and prevents electrical appliances and speakers from moving. And can be used in furniture, electrical cabinets, cars, speakers, toys, handicrafts, etc.
Wide Applications
The closed-cell foam can be used in door and window gaps as a seal to maintain room temperature, and in cabinet gaps to prevent annoying creatures from entering the cabinets.
Joe in the Jeep
Reviewed in the United States on September 24, 2024
Arrived and applied as advertised.
Dave Robin
Reviewed in the United States on July 6, 2024
Used this to make a gasket for a flood barrier for a drier vent. It worked perfectly and deformed nicely to about half its initial thickness when the lid was screwed down. Just exactly what I had in mind. The back adhesive allowed a bit of repositioning before you press it down for good then feels permanent. Just right.
Mwc
Reviewed in the United States on May 3, 2024
They stick very well, as pleased with them.
Optimus Prime
Reviewed in the United States on December 27, 2024
Good padding - definitely good for crafts. Fairly sticky backing. Not worried about it coming off.
LAURIE DEVITIS
Reviewed in the United States on December 19, 2024
Has worked for what I intended.
James R
Reviewed in the United States on December 14, 2024
I used 1/4 " thick foam as a cheekpiece on my rifle stock, which required bending around a 1 1/2" diameter surface. The adhesive takes some time to achieve its maximum holding strength, and the closed-cell foam is elastic enough to flatten out again after bending. To overcome these tendencies, I tightly wrapped the foam to the stock with self-adhesive grip tape for two days and applied heat to the bend (hair dryer, about 140 degrees F) to get the foam to relax more quickly to its final shape. This has worked well so far with no need for additional adhesive to keep everything in place.
Customer
Reviewed in the United States on November 23, 2024
Package said 1/8" but product measures .180... not .125So pretty much 3/16"Another quality product here...
chris
Reviewed in the United States on November 12, 2024
Very nice adhesive on the padding, surprisingly so. Great product.
Recommended Products