Your cart is empty.
Your cart is empty.Product Description
Specifications
- Material: Iron
- Safe Working Load: 420 lbs
- Size: please refer to the picture
- Surface: Zinc-Plated
- Mounting Screws: M5
- Quantity: 6 Piece Pulley Wall Mount
Note:
- Please allow 1-3mm error due to manual measurement.
1-1/2 Inch Ceiling Mount Single Pulleys Designed for Use with Rope or Cord in Indoor and Outdoor Applications.
- Fit for for 3mm-10mm wire rope, climbing rope or twine.
- No noise, smooth save effort.
- Zinc plated finish provides corrosion resistance.
USED FOR:
- Home fitness, outdoor work and pulley lift system for kayak storage.
- DO NOT USE FOR OVERHEAD LIFTING
JK Looze
Reviewed in the United States on February 11, 2025
These are well made. They have deep enough channels that the line easily stays in them.
Gene Russell
Reviewed in the United States on July 18, 2024
I bought these to move the 6 hand winches for my 5 kayaks and 1 canoe that hang from the ceiling of the garage. 4 or 5 years ago I bought half a dozen from TSC; well made, ball bearings and they work great (and today are over $12 each). The new location the ropes go through a pair of pulleys to lift the watercraft, then to the east wall and turn a corner at the south wall then turn downwards to the winches: originally the ropes just ran along the east top plate and turned down to the winches. These will be used on the new location to redirect downwards while the original ones will redirect at the corner. Typical imported product. Difficult to disassemble and reassemble because the sleeve bearing (was expecting ball bearings- think I confused products) are a tiny bit too long and requires some force in each procedure. They are rated for 420 pounds, N.F.Way, but my application is for 70 pounds or less for each pulley. I hope they will work but I certainly would not trust them anywhere near that 400 pound mark and I’m not confident they would survive 150 pounds. I am marginally satisfied and if they do work well, I’ll saved about $50 over TSC higher quality. Worst case, I’ll lube the axles with graphite
Seth G. Petro
Reviewed in the United States on January 15, 2024
Not very many options for a pulley like this. That being said, they are working well. Only complaint that I have is that the pulleys have the screw bosses for mounting them offset, but they aren't offset enough to prevent the pulley axle from hitting.
Remy
Reviewed in the United States on July 5, 2023
Works on ceiling wall floor versitle mount. The removable wheel is awesome when working with wire cable that has loops on the end.
MNBased
Reviewed in the United States on May 18, 2023
As described--
14carbonman
Reviewed in the United States on June 11, 2022
Not so long ago I bought two pulleys like these from Amazon. They were made by Stanley, had a nice smooth finish, and the little details like the chamfered ends of the axle pins were all nicely done. These new knock offs, on the other hand, might be just as durable - might - but are rather roughly manufactured. Saddest of all is that they have no name, no one willing to admit to producing them, and no country of origin. I will use them reluctantly, but am disappointed.
Steve Gerstl
Reviewed in the United States on November 18, 2022
I would like to see bronze bushings and tighter tolerances in the pulleys for smoother operation. Very strong otherwise.
Herb Friedrichs
Reviewed in the United States on May 30, 2021
I used this to create a platform that I can lower and raise in my garage. These were perfect for what I needed.
Recommended Products
$140.00
$ 64 .99 $64.99